Zanussi ZSF2450 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина Zanussi ZSF2450. Zanussi ZSF2450 20 сторінок. Product manaul
Також для Zanussi ZSF2450: Посібник користувача (20 сторінок), Посібник користувача (20 сторінок)

Друкувати сторінку

– The countdown of the delay start starts.

– The countdown of the delay start decreases with

steps of 1 hour.

– When the countdown is completed, the washing

programme starts automatically.

Do not open the door during the countdown to pre-

vent interruption of the countdown. When you close

the door again, the countdown continues from the point

of interruption.

Cancelling a delay start:

1. Press and hold function buttons B and C until all the

programme lights come on.

– When you cancel a delay start, you also cancel the

washing programme.

2. Set a new washing programme.

You can select the washing programme and delay

start also with the door closed. When you press a

programme button you have only 3 seconds to select a

different washing programme or a delay start. After these

3 seconds, the selected programme starts automatically.

End of the washing programme

Switch off the appliance in these conditions:

Care and cleaning

Warning! Switch the appliance off before you clean

the filters.

Cleaning the filters

Important! Do not use the appliance without the filters.

Make sure that the installation of the filters is correct.

Incorrect installation will cause unsatisfactory washing

results and damage to the appliance.

• The appliance stops automatically.

• The display shows 0.

• The end-of-programme indicator light comes on.

1. Press the on/off button.

2. Open the door.

3. For better drying results, keep the door ajar for some

minutes before you remove the dishes.

Let the dishes cool down before you remove them from

the appliance. Hot dishes are easily damaged.

Standby mode

If you do not switch off the appliance at the end of the

washing programme, the appliance automatically goes

into standby mode. The standby mode decreases energy

consumption.

Three minutes after the end of the programme, all indi-

cator lights go off and the digital display shows one hor-

izontal bar.

Press one of the buttons (not the on/off button), to go back

to end-of-programme mode.

Remove the filters A and B

from the bottom of the ap-

pliance.