Zanussi ZSLN2321 Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина Zanussi ZSLN2321. Zanussi ZSLN2321 25 сторінок.

Друкувати сторінку
Zanussi ZSLN2321 Посібник користувача
HOW TO FILL THE RINSE AID DISPENSER
B

DAILY USE

1. Open the water tap.
2. Press and hold
activated.
3. Fill the salt container if it is empty.
4. Fill the rinse aid dispenser if it is empty.
5. Load the baskets.
6. Add the detergent.
7. Select and start a programme.
8. Close the water tap when the programme is
complete.
USING THE DETERGENT
A
C
CAUTION! Only use detergent
designed specifically for dishwashers.
1. Press the release button (B) to open the lid (C).
2. Put the detergent in the compartment (A). You
can use detergent in tablets, powder or gel.
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the lid locks into
position.
12
C
A
until the appliance is
B
CAUTION! Only use rinse aid
designed specifically for dishwashers.
1. Press the release element (A) to open the lid
(B).
2. Pour the rinse aid in the dispenser (C) until the
liquid reaches the marking "FILL".
3. Remove the spilled rinse aid with an absorbent
cloth to prevent excessive foam formation.
4. Close the lid. Make sure that the lid locks into
position.
HOW TO SELECT AND START A
PROGRAMME
1. Press the button dedicated to the programme
you want to set.
The light related to the button flashes.
2. Activate Extra Power if desired.
3. Close the appliance door to start the
programme.
HOW TO SELECT AND START THE
PROGRAMME PRE-RINSE
1. To select Pre-rinse, press and hold 30 min for
3 seconds.
The light related to the button flashes.
Extra Power is not applicable to this
programme.
2. Close the appliance door to start the
programme.
HOW TO ACTIVATE EXTRA POWER
1. Select a programme.
2. Press Extra Power.
The light related to the button is on.
Extra Power is not a permanent option
and must be activated every time
before you start a programme.
It is not possible to activate or
deactivate Extra Power while a
programme is running.
Activating Extra Power increases the
water and energy consumption as well
as the programme duration.