Zanussi ZCG551GNC Посібник користувача - Сторінка 19
Переглянути онлайн або завантажити pdf Посібник користувача для Кухонні плити Zanussi ZCG551GNC. Zanussi ZCG551GNC 28 сторінок. Product manaul
Друкувати сторінку
To replace the glass panels obey the pro-
cedure in opposite sequence. Before you
lower the trim attach the A trim part to the door.
Refer to picture.
Oven lamp
Warning! There is a danger of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch
off the circuit breaker.
Put a cloth on the bottom of the oven for
protection of the oven light and glass cov-
er.
What to do if...
Warning! Refer to "Safety information"
chapter.
Problem
The appliance does not operate.
The appliance does not operate.
The grill, burners, ovens and timer
do not work.
The grill, burners, ovens and timer
do not work.
The grill, burners, ovens and timer
do not work.
Only main oven does not work.
There is no spark when lighting
the gas.
The flame is blow out immediately
after ignition.
www.zanussi.com
Replacing the oven lamp
1. You can find the lamp glass cover at the
2. Clean the glass cover.
3. Replace the oven lamp with an applicable
Important! Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The fuse in the fuse box is re-
leased.
The appliance is too hot.
There is no electrical supply.
There is no electrical supply.
There is no gas supply.
Time is not set.
Burner cap and crown are placed
uneven.
Thermocouple is not heated suffi-
cient.
back of the cavity.
Turn the lamp glass cover counterclock-
wise to remove it.
300 °C heat-resistant oven lamp.
Control the fuse. If the fuse is re-
leased more than one time, refer
to a qualified electrician.
Cool down the appliance for some
hours
Make sure that the unit is connec-
ted and the electrical supply is
switched on.
Examine the house electrical in-
stallation fuse.
Examine the house gas supply,
use other gas appliance (Central
heating or gas fires).
Set the time
Make sure that the burner cap and
crown are in correct positions.
After lightning the flame, keep the
knob pushed for approximately 5
seconds.
Remedy
19