Alecto DBX-77 Інструкція з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Радіоняня Alecto DBX-77. Alecto DBX-77 8 сторінок.

INTRODUCTION

Thank you for purchasing our DBX-77 baby monitor. Your unit has been

manufactured and checked under the strictest possible quality control to ensure

that each monitor leaves the factory in perfect condition. If in the unlikely

event you find any defects or have any problem, please contact your dealer,

our branch or service center.

Please read this manual carefully to obtain maximum performance & extended

service life from the unit.

FEATURES

- 16 selectable digital codes provide high degree of immunity from interference.

- Selectable two channels with crystal clear operation.

- Audio and visual alert for out-of-range and low battery warning on receiver.

- Adjustable sensitivity for microphone on transmitter.

- Automatic back-lighted LCD for easy viewing.

- Moving graphics on LCD to alert parent when baby cries.

WARNING

The DBX-77 baby monitor should not be regarded as a medical device.

Premature babies or those considered to be at risk should be under the

supervision of your doctor or health professional.

Direct supervision of your baby at a regular interval by a responsible adult is

strongly recommended in addition to using the DBX-77.

The Alecto DBX-77 complies with the essential requirements and provisions as

described in the European Directive 1999/5/EC. The DBX-77 is allowed for

usage in: The Netherlands, Belgium, Luxembourg, Spain,

Switzerland, Austria and Germany. The declaration of

conformity can be found on the website www.alecto.info

SETTING OF DIGITAL CODES

Slide open the battery cover after unlocking the lever, with the

help of a pointed object, select one of the sixteen settings of the

four dip switches, make sure the setting and number sequence

are the same in both transmitter and receiver.

N.B. In case you still find interference in actual operation, either change to

another channel or change the settings of the four dip switches to a new

combination. Always make sure to keep the same setting in both transmitter and

receiver.