Alemite 343684 Інструкція з монтажу та обслуговування - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з монтажу та обслуговування для Блок управління Alemite 343684. Alemite 343684 12 сторінок. Fluid solenoid valve and pulse meter kit
Друкувати сторінкуAssembly
Metering gears
NOTE
Position gear with magnets († Fig. 5).
Before assembly verify gears rotate
and do not bind. Manually turn gears
through three rotations to verify free
movement.
Meter will not function properly if
gears are incorrectly installed.
1 Install gear (5) with magnets into
housing (3). Make sure to locate gear
properly in housing († Fig. 4, page 6).
2 Place second gear into housing. Verify
gear engages magnet gear as shown.
3 Rotate gear assembly by hand to make
sure gear teeth are properly engaged.
4 Install and seat o-ring (4) into oval
groove in housing.
5 Position housing cover (6) onto housing.
6 Install washers (7) and screws (8) that
secure housing cover to housing.
7 Tighten screws in a criss-cross pattern
to 90 in-lbf (10.2 Nm).
Switch module
8 Position switch module (1) onto housing.
9 Install screws (2) that secure switch
module to housing. Do not overtighten.
Pulse meter housing assembly with gears
B
A
Item
Description
A
Magnet position indicator mark
B
Gear with magnets
C
Housing (3)
7
Fig. 5
C