Alemite 3641 Посібник з експлуатації - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Блок управління Alemite 3641. Alemite 3641 14 сторінок. Electronic preset metered control valve

Друкувати сторінку
Electronic Preset Metered Control Valve
Solenoid
19. Drop Detent Ball (47) into the hole in the Housing.
20. Screw Solenoid (48) into the Housing securely.
21. Carefully push the terminal connector [no polarity] onto the
Solenoid pins.
22. Install Keypad (19) into the holes of the Circuit Board
Assembly.
23. Install Top Case (16) onto the Housing.
24. Install Screws (18) that secure the Housing to the Top Case.
• Tighten the Screws securely.
25. Install one additional Screw (17) that secures the Top Case to
the Housing.
• Tighten the Screw securely.
26. Install and seat each Battery terminal onto Bottom Case (41).
• Make sure each terminal is fully seated.
27. Position the Bottom Case over the Lever and onto the
Housing.
• Route the wiring properly with no kinks.
NOTE: The Bottom Case may contact the Sole-
noid connector. This is permissible.
28. Install Screws (46) that secure the Bottom Case to the
Housing.
• Tighten the Screws securely.
29. Insert the tab of Partition (45) into the Bottom Case.
30. Insert the tabs of Case Cover (44) into the Bottom Case and
over the Partition.
31. Install Screws (43) that secure the Case Cover and the
Partition to the Bottom Case.
• Tighten the Screws securely.
Battery Door
32. Position Battery Door (42) [with batteries] to the Bottom
Case.
33. Insert Screws (43) into the Battery Door.
• Tighten the Screws securely.
Swivel
34. Install Screen (14) and O-Ring (15) into Swivel (13).
NOTE: O-Ring (15) is slightly smaller than O-Ring
(12).
35. Install O-Ring (12) onto the Swivel.
36. Screw the Swivel into the Valve's Housing.
• Tighten the Swivel securely.
Alemite Corporation
Extension and Nozzles
Non-Drip Nozzle (Automatic w/ Manual Lock)
NOTE: Refer to Figure 8 for compo-
nent identification.
1. Install Gasket (55) into Angle Body (54).
2. Install Washer (56) into Screw Assembly (57).
3. Thread the Screw Assembly into the Angle Body.
• Tighten the Screw Assembly securely.
4. Install O-Ring (50) onto Nozzle (49).
5. Install and seat V-Block (51) [heel end first] onto
Stem (52).
6. Install the Stem assembly into the Nozzle.
7. Install Spring (53) into the Stem.
8. Screw the Nozzle assembly into Angle Body.
• Tighten the Nozzle securely.
Extensions
1. Connect the components of the extension
assembly and tighten securely.
2. Screw the extension assembly into Control
Valve (11).
• Tighten the extension securely.
13
SER 3640
Revision (10-04)