Nikon SLRs Series Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Цифрова камера Nikon SLRs Series. Nikon SLRs Series 30 сторінок. Modern classic slrs series

Друкувати сторінку

1. Loading the Camera

Loading the camera

Turn the lock on the camera baseplate to the "open" position as shown by the arrow Slide

the one-piece baseplate and camera back downward and off.

Drop a film cartridge or loaded cassette into

the film chamber so that the notched end of

the rewind knob engages the cassette or

cartridge. Insert the end of the film leader

into any of the four slots in the take-up

spool.

Unloading

Set the A-R ring around the shutter release button to "A" (Advance) and wind the film so

that it passes under the take-up spool with its emulsion side facing out. Make sure that

the perforations on the film mesh with the sprockets.

Replace the camera back and lock it by turning the lock to the "close" position. Fold out

the rewind crank and turn the rewind knob gently in the direction of the arrow to take up

any slack in the cartridge.

Stroke the film-advance lever to cock the shutter and make two blank exposures (or until

the frame counter on the film-advance fever rests at 1) These blank exposures will

dispose of the portion of film exposed during loading.

Make sure that the rewind

knob rotates in the direction

opposite the arrow when the

film is advanced. This

indicates that the film has been

loaded correctly and is being

advanced.

Set the A-R ring to "R"

(Rewind), unfold the rewind

crank and turn it with a

constant, gentle pressure in the direction of the arrow. Avoid uneven or excessively fast

rewinding. The red dot on the shutter release button rotates while the film is being

rewound and stops when the end of the film has been wound off the sprockets. Then the

camera back may be opened.

Caution: Never load the camera in direct sunlight as this may result in accidental fogging of the flm. To avoid

possible scratching the film guide rails by the pressure plate when replacing the camera back without a roll of