ARO 8506-A Посібник оператора - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник оператора для Викрутка-шуруповерт ARO 8506-A. ARO 8506-A 19 сторінок. “o” series “qrt” screwdrivers

MODEL IDENTIFICATION

MODELS WITH -EU SUFFIX ARE "EC" COMPLIANT MODELS.

NOTE: GENERAL PURPOSE WRENCH 37167 FURNISHED WITH -A AND -T MODELS.

DISASSEMBLY AND ASSEMBLY OF TOOLS

Disconnect air supply from tool or shut off air supply and exhaust

(drain) line of compressed air before performing maintenance or

service to tool.

DRIVE SECTION

Remove clutch housing from tool (left hand threads); grasp clutch

Before starting to disassemble or assemble this tool (any part or

assembly and pull from gearing.

completely), be sure to read "Inspection, Maintenance and Instal-

lation" section.

GEARING SECTION

To minimize the possibility of parts damage and for convenience

Remove drive section. Hold motor housing in a suitable fixture or

the steps for disassembly or assembly listed on the following

gear.

strap wrench and remove gearing using a wrench on flats of ring

pages are recommended.

The basic sections and instructions for removing them from the

MOTOR SECTION

tool are as follows:

Motor may be removed from housing after removal of gearing.

TYPICAL CROSS SECTION OF TOOL