ARO GV08A-05S-7 Посібник оператора - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник оператора для Електроінструмент ARO GV08A-05S-7. ARO GV08A-05S-7 12 сторінок. Sanders/polishers
MAINTENANCE SECTION
TROUBLESHOOTING
GUIDE
Trouble
Probable Cause
Low power or low free speed
Rough operation
Scoring
Air leaks
or broken Vanes
. .
Worn or broken Cylinder
build-up in the motor
Worn or broken Rear Rotor
Bearing or Front Rotor Bearing
Bent Arbor
Improper assembly
Worn Valve Throttle and/or
Throttle Valve Seat
Oil Chamber Plug worn or not
tight
Solution
Check the air pressure at the Inlet. The pressure
must not exceed 90 psig (6.2 bar/620 kPa).
Clean the Screen in a clean, suitable, cleaning
solution. If it cannot be cleaned, replace it.
Never operate a Sander or Polisher without an
Inlet Screen. Ingestion of dirt into the Sander
or Polisher can, in some cases, cause an unsafe
condition.
Replace the complete set of Vanes.
Replace the Cylinder if it is worn or broken or if
the bore is scored or wavy.
Lubricate the Sander or Polisher as instructed in
LUBRICATION.
If lubrication does not result in
satisfactory operation, disassemble the motor,
inspect and clean all parts.
Examine each Bearing. Replace the Rear Rotor
Bearing Seal Assembly if worn or damaged or
replace the Front Rotor Bearing.
Mount the Arbor on centers. Check the bearing
diameter runout with an indicator. Replace the
Arbor if runout exceeds .002" Total Indicator
Reading.
Make certain that all motor parts are properly
aligned prior to clamping the motor assembly.
Replace worn parts.
Tighten the Plug. If the problem persists, replace
it.
SAVE THESE INSTRUCTIONS.
DO NOT DESTROY.
Part of worldwide
Ingersoll-Rand
PN49999-457
03540481