3D Hobby Shop Velox VR-1 Посібник з монтажу - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop Velox VR-1. 3D Hobby Shop Velox VR-1 17 сторінок.

Hinge the ailerons onto the wings using 2 large drops of thin CA on each hinge.

Remove the covering over the aileron servo locations and the aileron control horn slots as shown.

Install aileron horns into the ailerons using a generous amount of thick CA glue. Assemble the aileron

pushrods as you did the elevator pushrod. Attach a 6-8" (200mm) servo extension to each aileron servo.

Use heat shrink tubing of a servo plug lock on this connection. Use the included string to pull the servo

wire through the wing and install the servo, servo arm, adjustor and pushrod just as you did on the

elevator. After installation, the pushrod may be trimmed to length.