3D Hobby Shop Velox VR-1 Посібник з монтажу - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop Velox VR-1. 3D Hobby Shop Velox VR-1 17 сторінок.

Друкувати сторінку
8
Use a piece of tape to immobilize the rudder, and make sure the rudder servo is centered.
Assemble the cables onto the pull wire ends, crimp, and add a drop of thin CA to the crimp joints. The
cables cross once inside the fuselage to form an X shape. It is perfectly fine for the cables to lightly rub
against each other. Use the adjustors to set the cable tension. We only want the cables tight enough not
to sag. Any tighter and this will cause drag on the servo and rob servo power.