Acoustic B600C Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Acoustic B600C. Acoustic B600C 12 сторінок.

BASS GUITAR AMPS

B300C BACK PANEL

1. Link Out: Sends Output to another Acoustic™ bass combo or head with a 'Link In' input. This allows the user to link 2 combos or

heads together for more power and allows the sound to be controlled from one master amplifier

2. Link In: Accepts Input from another Acoustic™ bass combo or head's 'Link Out' output. This allows the user to link 2 combos or

heads together for more power and allows the sound to be controlled from one master amplifier

3. Effects Send: 1/4" two-conductor jack sends signal to external effects or signal processing devices

4. Effects Return: 1/4" two-conductor jack returns signal from external effects or signal processing devices

5. Footswitch: 1/4" Tip/Ring/Sleeve jack for attaching an optional 2 button latching footswitch. Controls Overdrive on/off and

Effects Loop on/off (Note: Engage overdrive switch after connecting footswitch, then use attached footswitch to turn off/on overdrive)

6. Tuner Send: This provides an additional send for easy routing of the instrument signal to a tuner. Attach electronic instrument tuner

via 1/4" two-conductor instrument cable

7. Pre/Post EQ Switch: Switches the direct balanced output between pre and post EQ operation. In 'pre' setting, the instrument

signal will be sent to the balanced output prior to any preamp EQ adjustments. In 'post' setting any EQ applied in the preamp

stage will be present in the signal sent to the balanced output.

8. Direct Output: XLR direct balanced output connector jack for connection to an external PA, sound board or recording console

9. Ground Lift Switch: Lifts the ground from the XLR direct output. Useful for eliminating hum when the direct out is used

10. Level: Adjusts the level of the direct output signal

11. Speaker Outputs: 1/4" speaker jack and locking-barrel type jack for attaching external speakers (minimum 4 Ohm total load)

12. AC Power Connection and Fuse: Connect included IEC power cable here. Fuse cap contains fuse for circuit protection