ClearWater Lights CANopener Посібник - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник для Аксесуари для мотоциклів ClearWater Lights CANopener. ClearWater Lights CANopener 13 сторінок.

Друкувати сторінку

Clearwater CANopener operation and features

AUXILIARY CANopener RELAY DRIVES

•

Auxiliary turn on (1/4 amp maximum) Useful for turning on aux fuse boxes or

a PDM-60.

•

Auxiliary horn (1/4 amp maximum) Useful for adding an aux air horn.

use relay.

•

Auxiliary high beam relay drive (1/4 amp maximum) Useful for adding an aux

high beam.

WARNING:

Do not connect auxiliary accessories without a relay!

(For Billie/Accessory Cable)

Ground

Brake/Tail Light

12V Motory Start*

High Beam*

Horn*

FACTORY DEFAULT RESET

To reset the CANopener to the factory settings, press and release the (TSC) button,

hold the left turn signal switch and press and release the flash-to-pass button (6)

times . All factory preset dimmer levels and modes will be selected. A successful reset

is indicated by five flashes of all Clearwater lights.

DIXI FUNCTIONALITY

Dixi lights operate similarly to two sets

of our lights. The Outer Ring of LEDs (A)

can be turned on and off by holding in

the TSC for 2 seconds just like a set of

Kristas, Ericas or Sevinas.

The Inner LEDs (B) are designed to come on with the engine just like a set of

Darlas but can be shut off (Version 2.3+) by holding the TSC Left for 5 seconds and

turned back on by holding the TSC to the right for 3 seconds.

The Inner and Outer ring of LEDs are dimmed independantly using the same

dimming operation as the Krista/Erica/Sevina channel for the outer ring of LEDs

and as Darlas for the inner LEDs. Refer to Page 5, Step 2 for further dimming

operation details.

CANopener Wiring Key

*Relay Drive

Note: These are all 12v

signals that would be

used to trip a relay that

is powered by the bike's

battery.

Page 8

MUST

Page 9