ACP 20077006 Посібник з безпеки продукції - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з безпеки продукції для Мікрохвильова піч ACP 20077006. ACP 20077006 4 сторінки. Commercial microwave ovens and combination ovens

Друкувати сторінку

Installation & Cleaning

Unpacking Oven

•

Inspect oven for damage such as dents in door or inside oven cavity.

•

Report any dents or breakage to source of purchase immediately.

Do not attempt to use oven if damaged.

•

Remove all packing materials from oven interior.

•

If oven has been stored in extremely cold area, wait a few hours

before connecting power.

• A protective film is used to prevent scratching of the outer case during

transportation. Peel off the film from the exterior of the oven before

installation.

•

The warning label provided with the oven must be placed in a

conspicuous location near the oven.

Radio Interference

Microwave operation may cause interference to WiFi network, radio,

television, or a similar oven. Reduce or eliminate interference by doing the

following:

•

Clean door and sealing surfaces of oven according to provided

instructions.

•

Place WiFi network, radio, television, etc. as far as possible from oven.

•

Use a properly installed antenna on radio, television, etc. to obtain

stronger signal reception.

Oven Placement

Do not install oven next to or above source of heat, such as pizza

•

oven

or deep fat fryer. This could cause microwave oven to operate

improperly and could shorten life of electrical parts.

• Do not block or obstruct oven filter. Allow access for cleaning.

•

Install oven on level countertop surface.

•

Outlet should be located so that plug is accessible when oven is in

place.

To avoid risk of electrical shock, severe personal injury or death,

unplug power cord or open circuit breaker to oven before cleaning.

Cleaning Interior, Exterior, and Door

Clean microwave oven daily with mild detergent in warm

water using soft sponge or cloth. Wring sponge or cloth to

remove excess water before wiping equipment. If desired,

boil a cup of water in microwave oven to loosen soil before cleaning.

DO NOT allow cooking residues such as grease or fat to remain

in oven interior for any length of time.

• Do NOT allow cooking residues to remain in oven cavity.

• Do NOT use abrasive cleansers or cleaners containing

ammonia.

These could damage finish.

• Do NOT use caustic cleaning products or those containing

ammonia, phosphates or chlorine in oven. These could damage

oven. Use non-caustic cleaner.

• NEVER pour water into microwave oven bottom.

• Do NOT use water pressure type cleaning systems.

• For more detailed cleaning instructions, see the Owner's

Manual on-line at www.acpsolutions.com.

SAVE THESE INSTRUCTIONS

Part No.20077006

Revised 7/15

CAUT IO N

To avoid risk of electrical

shock or death, this oven

must be grounded and plug

must not be altered.

Grounding/Earthing

Instructions

electric current, if an electrical short

occurs. This oven is equipped with

a cord having a ground wire with

a grounding plug. The plug must

be plugged into an outlet that is

properly installed and grounded.

Consult a qualified electrician or

servicer if grounding instructions

are not completely understood, or if

doubt exists as to whether the oven

is properly grounded.

Do not use an extension cord.

If the product power cord is too

short, have a qualified electrician

install a three-slot receptacle. This

oven should be plugged into a

separate circuit with the electrical

rating as provided in product

specifications (available on ACP's

website at www.acpsolutions.com).

When a microwave oven is on a

circuit with other equipment, an

increase in cooking times may be

required and fuses can be blown.

External Equipotential

Earthing Terminal

Equipment has secondary earthing

terminal. Terminal provides

external earthing connection used

in addition to earthing

prong on plug. Located

on outside of oven

back, terminal is

marked with symbol

shown below.

WARNING

MUST

Oven

grounded. Grounding

reduces risk of electric

shock by providing an

escape wire for the

(export only)

 2015 ACP, Inc.

Cedar Rapids, Iowa 52404