Artis Real-Wood Інструкції з монтажу та обслуговування

Переглянути онлайн або завантажити pdf Інструкції з монтажу та обслуговування для Варильна поверхня Artis Real-Wood. Artis Real-Wood 2 сторінки.

Друкувати сторінку

making life nice and easy

REAL-WOOD INSTALLATION AND MAINTENANCE INSTRUCTIONS

FIG. 6

Place the hardboard spacer strips provided in the installation kit on top of the cabinets to help the air

circulate. The hardboard strips should be placed every 60cm apart and where cabinets meet

together.

FIG. 7

You can decide yourself which way the worktop will move by selecting either the front or the

rear edge to fix your worktop into position.

FIG. 8 & FIG. 9

Joins have to be made with jointing bolts. Worktop biscuits must also be used to keep the

tops flush.

Use 3 bolts for a 650mm worktop. Drill holes into the tops of the cabinets, as it is very important that

the bolts are fastened from the inside of the cabinets. Use a butt and scribe joint rather than a mitre

when installing worktops in corners.

Place the 2 tops together and check to make sure all joints are square and true. Make any necessary

adjustments. On 90O corners, the worktops have been designed to always form right angled joins.

Insert the worktop biscuits and push the worktops together until they are 3-4mm apart and mount

the jointing bolts. Apply sealant from the installation kit along the joint and tighten the jointing bolts

so the joint is tight. (Do not over-tighten the bolts).

Remember to always carry out a final tightening and adjustment of the joints to complete

the installation. Clean off the excess bead of sealant whilst still wet.

FIG. 10

Always protect the worktop against heat (heaters/cookers) and moisture (dishwashers, washing

machines etc.) with aluminium foil. Glue the aluminium foil onto the underside of the worktop before

fixing. Make sure the foil covers the whole area of the worktop where the appliance is to be

positioned.

Household appliances such as coffee makers, toasters and microwave ovens should never

be placed directly onto the worktop surface as the wood may dry out and cracks may appear.

FIG. 11

Particular attention should be given to free-standing cookers. Apply aluminium strips with silicone

sealant to the edges of the worktop closest to the cooker.

Small cracks may occur but they are not damaging to the worktop, simply treat with extra oil.

FIG. 12

Free standing worktops measuring more than 250mm must always be supported by frames or the

insertion of T-bars to avoid bowing. If a worktop is to be fitted over a radiator, aluminium foil must be

used to the underside to deflect heat.

UPSTANDS

Upstands must always be installed after the worktops have been secured to the kitchen units.

They can be fastened by using silicone onto the back edge of the worktop surface and wall. It

is very important that the sealing against the worktop and wall is carried out correctly so that

water cannot get underneath the upstand. This will prevent damage and miscolouring of the

wood over time.

making life nice and easy

www.artis.co.uk

INSTALLATION AND MAINTENANCE INSTRUCTIONS

ARTIS

real-wood

making life

nice and easy

Please note:

Installer should read these instructions before installation

and pass them onto the consumer for advice on cleaning

and maintenance.

Jan 09 edition