Artison RCC600-SM Посібник з монтажу - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з монтажу для Сабвуфер Artison RCC600-SM. Artison RCC600-SM 19 сторінок. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
Також для Artison RCC600-SM: Посібник з монтажу (13 сторінок)
Друкувати сторінкуPOWER MODES
POWER MODES
II::
W
0"
....
"
z
:::>
iii:
+12V
o
< ....
TRIGGER
r:t=J
INPUT
rn
1. Select either:
ON - Always On.
AUTO - On with Signal Sense, without signal it will stay on for :::::15 minutes.
TRIGGER - On with a 12 Volt trigger.
2. +12V Trigger Input - Use the Green Phoenix Connector to connect a 12 volt trigger wire
from your other equipment, the polarity on the connector can be either way.
SETUP MODES
- - SETUP MODES - -
PHASE
LOW PASS
80Hz.
O'~l00' 4OHz~60Hz
OJ
OJ
----J L.-
---J L-
eo
Bame
CLOSED
12<1B
24dB
EQ
BOX
SLOPE
1. EQ - Select the appropriate setting based on these guidelines:
00
Baffle - The RCC 600 Subwoofer Module is installed in a wall that has an air
volume of
~2.8
fe.
CLOSED BOX - The RCC 600 Subwoofer Module is installed in an Artison In-Wall
or In-Floor Pre-Build Box, or is the RCC 600 Freestanding
Subwoofer.
IMPORTANT: In an installation of two RCC600-SM's that are being powered by one
RCC600-SA, both Subwoofer Modules need to be in either Pre-Build Boxes or be in
Infinite Baffles. You cannot connect two RCC 600 Subwoofer Modules that are in
different environments to the same RCC 600 Subwoofer Amplifier.
10