Artistic License vSplit iso xlr8-8 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Системи вводу/виводу Artistic License vSplit iso xlr8-8. Artistic License vSplit iso xlr8-8 14 сторінок. Versasplit dmx/rdm; crmx; ethb input module
Друкувати сторінкуSplit/Fix Mode
Normal splitter operation is achieved by
setting the switch next to the input connector
to 'Split'. In splitter mode, the outputs operate
as bi-directional RDM ports and all DMX data
received is passed onto the outputs.
Alternatively, set the switch to 'Fix' if you are
experiencing product compatibility problems.
Unfortunately, there are numerous products
on the market which will not accept the wide
range of legal DMX timings and data. Fixer
mode attempts to clean-out any unusual or
non-standard timing and data before sending
to the output. This includes stripping out all
non-zero start codes (including RDM), forcing
a 512-channel footprint and calming any
timing jitter.
The detailed fix specification is as follows:
Accepts and corrects break in range
y
56 µs – 1000 µs and outputs 250 µs
Accepts and corrects MaB in range
y
5 µs – 1000 µs and outputs 30 µs
Accepts and corrects MbB in range
y
0 µs – 1000 µs and outputs 30 µs
Accepts channel count 1 – 512 and
y
outputs 512
Accepts refresh period from 23 ms –
y
1000 ms and outputs 30ms
Filters out multiple consecutive breaks
y
Re-times bytes of 1 stop bit to 2 stop bits
y
Filters out all non-zero start code packets
y
Re-times digital signal
y
LED indicators
The DMX/RDM input modules feature a set
of LED indicators: Iso, DMX and Pow/Fix. The
meaning of each is as follows:
Iso
y
- Green: the input isolation DC supply
is working
- Red: the input isolation DC supply is
not working (indicating that the circuitry
has probably been electrocuted)
versaSplit User Guide
DMX
y
- Off: no data received
- Green: DMX and RDM received
- Yellow: DMX only received
Pow/Fix
y
- Green: power on
- Red (split mode): data error or collisions
detected
- Red (fix mode): data fixing is occurring
If using two DMX/RDM modules in versaSplit
duo, each module can be set independently
to splitter or fixer mode. The individual outputs
should be switched to A or B depending on
which mode is required.
CRMX wireless DMX input
module
When versaSplit is fitted with one (or two)
CRMX wireless DMX input modules, it acts
as a one (or two) input splitter / data fixer.
Conceptually, the functionality is similar to the
DMX/RDM modules. Where it differs is in the
method of DMX delivery (radio); also, RDM is
not currently supported.
The radio link should activate a few seconds
after the transmitting device is set to connect.
To deactivate the radio link, press and hold
the 'Link' button on the input module for 3
seconds.
If using two CRMX wireless DMX
modules in versaSplit duo, each
module can be set independently
to splitter or fixer mode. The
individual outputs should be
switched to A or B depending on
which mode is required.
CRMX wireless
DMX input
module with
antenna
CRMX wireless
DMX input
module without
antenna
Page 7