AluTeam BR 248-2 Інструкція з монтажу Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Вантажівки AluTeam BR 248-2. AluTeam BR 248-2 12 сторінок. Box body kits
Друкувати сторінку
suspended
falling
objects
loads on the
crane
Risk due to
hazardous
high-pressure
materials
cleaners
Series 248-2 Assembly Instructions
•
•
•
•
•
1.3 Safety instructions
Pay attention to your own safety and to that of your employees.
Working with kits involves hazards. Therefore, caution is always
necessary, in particular, you should definitely:
toppling parts
or assemblies
... Wear safety gloves. Wear safety footwear, as heavy parts can fall.
... when unloading / transporting the kit in the transport rack using a
Risk of
scalding
... Place transport racks on level surfaces only and secure them against
1
... Always lift assemblies vertically, not at an angle! Never step under
... remove all packing straps in the specified order during assembly,
2
... lift the roof with a lifting beam or vacuum lifter only! The roof
... comply with all relevant legal requirements in your country, such
... ensure adequate ventilation when cleaning and sealing and follow
Dated 11/2021
To ensure water cannot penetrate the assembled box body, the
sealing cords
in the profiles must not show any signs of damage.
Connect the components directly using the screws supplied.
The assembly contact surfaces must be free from dirt.
Use the original screws and bolts, and use them only once (even for
repairs). Third party / used screws and bolts endanger operational
safety. Screws must not tilt. Never position the screws or bolts at an
angle and keep to the specified
specified weakens the strength and tightness of the body, a signifi-
cant exceedance can cause damage to components!
The body is not designed for docking operations! Set out the un-
derbody so that forces acting through rear bumper guards are trans-
into the auxiliary frames or the
ferred
The fastenings between the longitudinal chassis beams and chassis
frame must be made as described in the
respective chassis
manufacturer. The two front fastenings at least
must be spring-mounted. Otherwise, forces that occur, e.g. in case of
cornering, load changes or non-uniform loading, are transferred onto
the body and can cause cracks in the body structure.
Wear hearing protectionas well as safety goggles when working
with air screwdrivers, grills, grinding equipment, etc. Wear a helmet
when working with or near a crane.
crane, use a suitable lifting beam. If using a forklift truck, push the
transport rack completely onto the fork arms.
tilting and toppling, secure any assembly dollies against rolling
away.
raised loads! The suspension point/anchorage in the crane must al-
ways be above the assembly's centre of gravity!
always remove the white packing straps first. The individual compo-
nents and assemblies are held by a red packing strap. Secure the part
to be removed against toppling before cutting the packing strap.
mounting strips (airline rails) are used as an assembly aid only. They
must not be used to lift assembled box bodies.
as laws, regulations, etc. regarding road traffic and goods transport,
as well as all relevant occupational health and safety regulations.
This is the responsibility of the body builder.
the use, safety and disposal instructions of the adhesive / sealant
manufacturer. Request the safety sheet and the instructions for
use from the manufacturer as printed on the cartridge or contact
+49 (0)521 4173 -1110.
Previous instructions become invalid.
torques
(2.3). A torque lower than
chassis.
body guidelines of the
Risk of pulling out!
3 / 12