Ashly Power Amplifiers FET-200 Інструкція з експлуатації Посібник з експлуатації - Сторінка 13
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Підсилювач Ashly Power Amplifiers FET-200. Ashly Power Amplifiers FET-200 14 сторінок. Mos-fet power amplifiers
Також для Ashly Power Amplifiers FET-200: Інструкція з експлуатації Посібник з експлуатації (15 сторінок)
Друкувати сторінку
SIBILANCE
The
distortion
caused
by loud high
frequency
signals,
such
as
the
"Ssss..." sounds in hinnan speech.
SHELVING
Describes
an equalization action where all frequencies above or below
a
particular frequency are boost or cut.
SLOPE
In a filter or equalizer,
a description of the rate of boost or attenua¬
tion.
Usually specified in dB/octave (6, 12, 18, and 24dB/octave slopes
are most common).
The steeper the slope, the higher the "Q" in a filter.
THRESHOLD
An arbitrary signal level, above which a limiter or noise gate activates.
TRANSIENT
A sudden burst of energy in an audio signal,
such as a breath blast in a
microphone,
the
sound of a snare drum,
or a deep scratch in a
record.
Transients
frequently
reach peak levels of 10 to 30 dB
above
standard
operating level, and may cause distortion or even damage to equipment.
UNITY GAIN
Output level = Input level.
VGA
Voltage
Controlled
Amplifier.
An amplifier capable of both
gain
and
loss, controlled by a variable DC voltage.
WIRING, PHONE PLUG AND XLR
A stereo phone plug is wired + to the tip,
- to the ring,
and shield to
the sleeve. For a mono phone plug, combine - and shield, and connect both
to the sleeve.
An XLR (3 Pin) connector is wired + to pin 3,
- to pin 2,
and shield to
pin 1.
SIeeve
Mono Phone Plug:
(for unbalanced
inputs and outputs)
Stereo Phone Plug:
(for balanced in¬
puts and outputs)
XLR Type Connector:
(Male Shown)
12