Ashly TM-360 Посібник з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Підсилювач Ashly TM-360. Ashly TM-360 16 сторінок. Public address amplifier
Також для Ashly TM-360: Короткий посібник (1 сторінок), Короткий посібник (1 сторінок), Короткий посібник (1 сторінок), Короткий посібник (1 сторінок), Посібник з експлуатації (16 сторінок)

Operating Manual - TM-360 Public Address Amplifier

Rear Panel Features

1) AC Mains

This is the AC cord for connecting to 120VAC mains, 60Hz, 24W.

2) Main Speaker Outputs

This 5.08mm Euroblock connector is used for the main speaker output wiring. For low imped-

ance speaker loads, minimum 4Ω, connect between the COM and 16V/4Ω pins. For 25V or 70V

speaker loads (70V and 100V output taps on 230VAC models), the LINK wire must first be installed

between the 16V/4Ω pin and OPT IN pin, then connect the speaker load between COM and 25V or

70V pins.

3) Zone 2 and Preamp Outputs

In addition to the main 60 Watt amplifier output, there is a separate ZONE 2 output which is a

switch selectable mix of channels 1, 2, or 3. This output is not effected by the priority ducking/mute

action or by the bass/treble EQ controls.

The ZONE-2 output provides two signals; 1) a low impedance output that is capable of contin-

uously driving 1 Watt into an 8 Ohm loudspeaker, and 2) a 600 Ohms transformer balanced output.

Zone 2 output is controlled by the rear panel Zone 2 level control, as well as the three channel assign

DIP switches.

The PRE OUT connection is used for driving additional external devices with the same signal

that drives the main TM-360 power amplifier. The PRE OUT 600W output signal is taken before the

master volume control.

4) Zone 2 Level Control

This controls the level of the Zone 2 output signal.