AERMEC PXA I Посібник з використання та встановлення - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з використання та встановлення для Панель керування AERMEC PXA I. AERMEC PXA I 7 сторінок. Electronic control panel for fan coils
Друкувати сторінку
USE
Controls
To turn on the FCX U - FCS U - Omnia HL S / SM - Omnia UL S / MS fan coils first open the fins.
Speed selector (A)
-
+
A
This permits the required temperature to be set. The temperature corresponding with the selector set
at the central position depends on the set functioning mode (Heating 20°C, Cooling 25°C).
The differences of minimum and maximum temperature with respect to the central position are +8°C
and -8°C.
HEATING
20°C
12°C
-
+
C
D
-
+
OFF
Power down command. Standstill status might be of two types, Frost
Protection or All Off (contact the installation engineer to find out the set
configuration).
All Off: The fan coil is turned off.
Frost Protection: The fan coil is off but can start again in heating mode if the room temperature falls
below 7°C (the boiler must be on).
AUTO
The thermostat keeps the set temperature by changing the fan speed automatically.
The thermostat keeps the set temperature using the minimum, medium and top speeds of
the fan.
COOLING
25°C
17°C
28°C
-
DISPLAYS
Indicator lights
(C)
Red
Blue
Fuchsia
❍
❍
❍
●
❍
❍
❍
●
❍
◗◗
❍
◗◗
◗◗
❍
◗◗
❍
◗◗
◗◗
❍
◗◗
◗◗
◗◗
❍
❍
❍
❍
◗◗
❍
❍
❍
❍ = Switched off
● = Switched on
◗◗ = Flashing
Temperature selector (B);
FROST PROTECTION
33°C
-
+
(D)
Yellow
Working mode
❍
Switched off
●
Heating
●
Cooling
❍
Stand by Heating (water temperature not sufficient)
Stand by Heating in units with PLASMACLUSTER
◗ ◗
(water temperature not high enough)
❍
Stand by cooling (water temperature too high)
Stand by Cooling in units with PLASMACLUSTER
◗ ◗
(water temperature too high)
❍
Antifreeze
◗◗
Autotest for installation (combination of blinking of the two colours)
◗◗
Contact the After Sales Service
B
-
9°C
+
®
®
+
7