REVERSING THE DOOR HINGES
The door hinges on ASKO dryers are reversible. The
dryers are shipped left-hinged. To reverse them, follow
the steps below:
WARNING!
Switch off the main power supply
before you start this procedure.
1.
Remove the two 20 torx
screws on the bottom
of the bottom panel
then grasp the bottom
of the panel and pull it
forward and down.
2.
Remove the bottom hinge by
removing the three screws holding
the hinge in place.
3.
Supporting the door from the bottom,
pull it out and to the left as you turn
the hinge counter clockwise.
4.
Remove the hinge pin at the top.
5.
Turn the hinge upside
put the hinge pin into the
top hole.
6.
Transfer the top hinge pin
to the right side of the dryer casing.
7.
Loosen the two screws on both outer edges of the
door so you can remove the magnetic door catch
and the cover plate.
8.
Remove the magnetic
catch by pushing it up
then lifting it out from
the bottom.
9.
Remove the cover plate
on the opposite side of
the door by pushing it
down then lifting it out
from the top.
10. Reverse steps 8 and 9 to
place the door catch and cover plate into their new
positions.
11. Tighten the screws on the sides of the doors to hold
the magnetic catch and cover plate in place.
Page 8
12. Using a flathead screwdriver,
carefully remove the plastic plugs
in the upper and lower edge of the
door and place them in the empty
holes on the opposite side.
13. Remove the screw in the top right corner of the
bottom panel, as indicated in the illustration.
14. Now you are ready to mount the door on the right
side. Holding the door at an angle (as illustrated), fit
the hinge pin into the top hole.
15. Replace the bottom hinge with the screws in the
order illustrated at right (a, b, c).
Hinge
16. Replace the screw you removed
pin
in step 13 (d).
down and
17. Replace the lower panel.
18. Turn back on the main power.
2
2
1
2
2
Друкувати сторінку