Asko T781 Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Сушарка Asko T781. Asko T781 2 сторінки. User manual quick start guide en
Також для Asko T781: Посібник із швидкого старту (2 сторінок), Посібник з планування та проектування (19 сторінок), Посібник із швидкого старту (2 сторінок), Посібник із швидкого старту (2 сторінок)

Друкувати сторінку

Press the Power button to turn on the machine.

Load the dryer.

Clean the lint filter (see below).

Check that the door is clear of laundry then close it firmly.

Press the button for the desired program (P1–P4) and make any program changes.

Press Start. The machine will start.

The LCD window is easy to read and understand. The illustration below explains what each item on the LCD window is.

Program

When you press the Power button,

the display toggles between the

program numbers and the wash

program names, (e.g., Extra Dry,

Dry, etc.)

Preset Programs

Displays the program that

is selected/running.

The LCD window also displays the menus and options available when you customize the preset programs. Refer to your Use and Care

Guide for more details.

Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each load to ensure

maximum air flow and prevent possible overheating. To clean the filter, follow the steps below:

1. Grasp the handle and pull it toward you.

2. Remove the filter from the holder by pulling it up.

3. Open the filter and gently brush away any lint.

4. Fold the filter together and return it to the holder on the door.

5. Push the holder in until it snaps into place.

If Model T781 is not installed to pump out the condensed water into a drain or a sink, you should empty

the water container every three to five dryer loads, depending on the spin speed you use when you wash

the clothes. For example, clothes spun at 800 rpm will have more moisture when you take them out of the

washer than clothes spun at 1400 rpm. Therefore, the dryer will have to remove more water.

To empty the container, simply pull it out and pour out the water. This water is clean and can be used to

water plants.

If the container becomes too full, the machine will shut down. To restart the program, empty the container

and press Start. It may be a few minutes before the machine starts because it drains the excess water

from the sump before it restarts.

Do not remove the water container while the machine is running.

NOTE:

The dryer has a protection device that shuts the machine off if the temperature becomes too high. Overheating could occur if the lint filter is

clogged or if the fan or condenser unit (Model T781) needs to be cleaned. If the dryer shuts off during a program on Model T781, first, make

sure the condensation water container is empty. If that isn't the problem, check the lint filter. Lastly, it could be the fan or condenser unit needs

to be cleaned. See page 3 in your Use and Care Guide for more details.

P1 Extra Dry

P2 Dry

P3 Normal Dry

P4 Iron Dry

Start

Indicates that you pressed Start

and the program is running.

NOTE:

We recommend that you clean the lint filter after every load.

Program Time

When you start a program, the total time the

program runs is displayed. As the program

progresses, the time remaining displays. The

program time toggles between minutes (e.g.,

23) and hours (e.g., 1h).

Stop

Indicates that the program has ended

or that you pressed Stop.

Art. No. 80 646 44 Rev. 03