AmbuTrak AMB-1001 Anweisungen - Seite 3

Blättern Sie online oder laden Sie pdf Anweisungen für GPS AmbuTrak AMB-1001 herunter. AmbuTrak AMB-1001 4 Seiten.

Clip is allowed to bend to be able to attach to spoke. Spin wheel while looking at display to

see if computer is picking up the sensor (Standard 2-wheeled walker on left and middle,

rollator clip setup on right)

5. Back to the computer, press and hold both buttons on computer to reset. Computer will flash for

a few seconds. During this time, set number to "398". "398" is the correct circumference of a

standard 2-wheeled walker with 5'' wheels (this is the wheel size of most standard 2-wheeled

walkers). If your walker wheel is larger or smaller than 5'', you must set the number according to

the circumference of your walker wheel, in millimeters. For example, a 7.5''(diameter) walker

wheel the circumference = 191. Take this diameter number and convert to circumference. The

conversion from diameter to circumference formula is (diameter)x3.14. So in this case, (191) x

3.14 = 600. Put this number into the AmbuTrak by toggling the right and left buttons. The left

chooses the digit and the right button moves the digit place holder on the screen. Once you

have the number set to where you want, just wait and allow the screen to flash back to the

home screen.

And you're off! AmbuTrak will automatically turn on and begin reading distance (in feet) and

gait speed (in miles/hr) when someone starts using the walker. AmbuTrak will turn off after several

minutes to save battery life

Troubleshooting AmbuTrak:

ddfa