AMCOL 6000E Benutzerhandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Controller AMCOL 6000E herunter. AMCOL 6000E 19 Seiten. Electronic timing controller for forming and fabricating
Auch für AMCOL 6000E: Benutzerhandbuch (6 seiten)
Seite drucken
6 Priming/Re-priming the System
1. Fill the reservoir.
2. Open the ball valve on the bottom of the reservoir.
3. Open pumps by turning the T60A liquid adjustment screw counterclockwise.
4. Repeatedly cycle the injectors.
5. Once liquid reaches the spray point, readjust the T60A Posi-pump to
the desired setting.
6. Adjust spray air pressure if necessary.
7 System Troubleshooting
Check in order as listed
Fluid Volume Inappropriate
•
Injectors misadjusted: adjust individual injectors.
Incorrect cycle timing: readjust Injection Pulse Rate Solenoid.
•
Inconsistent Spray Volume to One Spray Point
•
Spray tip is clogged: simply remove, clean, and replace spray tip.
•
Spray tip is not properly attached: be sure spray tip is tightly threaded and secured,
and that the 1/8" liquid line is properly installed onto barbed connectors.
•
Spray tip is damaged: remove and replace.
•
Liquid or air hose is severed or incorrectly attached: reconnect or replace.
•
T60A Posi-pump needs to be rebuilt: see instructions on page 12.
Inconsistent Spray Volume to All Spray Points
•
Be sure the fluid reservoir ball valve is open.
•
Fluid level is low: refill reservoir.
•
Strainer on reservoir is clogged: clean or replace.
Mist or Fog
•
Manifolded dispensing air pressure set too high: adjust.
•
Individual spray point flow set too high: adjust.
Liquid from Back of Injector
•
Injector contact seals leaking: clean injector and replace O-ring.
6000E ELECTRONICALLY CONTROLLED PRECISION LUBRICATION SYSTEM
Operator's Manual
P A G E | 8