Flocorp GUARDIAN 1000 G1 Betriebsanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Messgeräte Flocorp GUARDIAN 1000 G1 herunter. Flocorp GUARDIAN 1000 G1 20 Seiten. Wireless monitoring system

Seite drucken

INSTALLATION

The Guardian 1000

uses Radio Frequency (RF) waves for communication to the nearest cellular tower and can

™

transmit at several times the power of a hand-held cellular phone. In general, if you can place a cellular telephone call

in the location where you wish to install the unit, then the Guardian should be able to communicate properly. However,

because of the inherent characteristics of RF communications, there are certain guidelines that should be followed when

positioning the unit.

Warning:

• Do not install the Guardian 1000

• Do not use the Guardian 1000

• Electrostatic discharge can damage sensitive electronic components. Be sure to discharge yourself by touching a

grounded metal object before opening the unit.

• The unit should be installed in an area free from overhanging metal structures, large obstructions, or equipment which

could generate RF or electrical interference.

• Do not install the unit below ground level unless provisions are made for an external antenna.

• Service may be limited in areas that do not have GSM cellular coverage and support SMS (Short Message Service).

• If the unit is installed in an area with poor signal strength, an external antenna may be required for reliable performance.

Please contact FLO-CORP Customer Service to determine your exact needs.

INITIAL INSPECTION

When you receive the Guardian 1000

there is any damage to the Guardian 1000

in the shipping container. Check for any missing items before you begin installation of the Guardian 1000

Note: The Guardian 1000

™

Verify that the antenna is present before proceeding.

Tools Required for Installation:

3/16" Flat screwdriver Large adjustable wrench

STAINLESS STEEL TANK PREPARATION

Please check the following before installation of the Guardian 1000

• A 2-inch diameter threaded opening is required for the installation of a Guardian 1000

Stainless Steel tanks are typically built with one or more 2-inch threaded "bung" opening. The tank's vent line can be

modified to provide both tank venting and access for the Guardian 1000

available. Refer to the procedure below for the installation into a vent line.

• For Ultrasonic Guardian 1000

ultrasonic readings.

(877) 356-5463

(p) 330-331-7331

where hazardous vapors are present.

™

where blasting is in progress.

™

unit, thoroughly inspect it for any damage which may have occurred during shipping. If

™

, contact the shipping company as soon as possible. Locate the packing checklist

™

is shipped with the antenna disconnected. It is located in a separate area within the shipping carton.

installations, verify that there are no obstructions within the tank which could alter the

™

(f) 330-331-7172

™

, if the vent is the only 2-inch threaded opening

™

www.FLO-CORP.com

™

REVA 1116