Floe PWC1300 Schnellstart-Quide - Seite 7

Blättern Sie online oder laden Sie pdf Schnellstart-Quide für Hebesysteme Floe PWC1300 herunter. Floe PWC1300 8 Seiten. Anchoring system
Auch für Floe PWC1300: Montageanleitung Handbuch (12 seiten)

Seite drucken

IMPORTANT NOTE:

The lift should be installed with 6" of water above the

top of the bunks while the lift is in the lowered position.

This will provide adaquete clearence for launching

and docking of your watercraft and also help prevent

float off in the raised position during high wave conditions.

Lifting Winch and Cable Installation Instructions:

Left side mounting shown, for right side

Fig. 4A

mounting See Step 5.

Fig. 4A Location

Insert winch post (item #11) into front leg of left

side frame weldment (item #2). Leave 5" of winch

post exposed. Fasten with (1) HHCS 3/8-16 x 3/4",

(1) 3/8-16 nut, & (1) 3/8" flat washer (items

#14,21, & 23). Torque to 35 ft. lbs.

Install manual winch (item #26) with the crank

spindle on the top and the cable out the bottom.

Loosen and remove the nut, bolt, and washers (end

without chain attached) on the 2" pulley assembly (item

#13). Insert the cable (item #28) and replace

hardware. Tighten to remove excess play in pulley.

Attach 2" pulley assembly to left side frame

weldment with (1) HHCS 3/8-16 x 3", (1) 3/8-16

nut, & (1) 3/8" flatwasher (items #17,19, & 21).

Torque to 10 ft. lbs.

Thread the other end of the cable through the (2) 3"

cradle pulley assemblies (item #8) & attach the

swedged end of the cable to the right side

weldment (item #1) with (1) HHCS 3/8-16 x 3", (1)

3/8-16 nut, & (1) 3/8" flat washer (items # 17,19,

& 21). Torque to 10 ft. lbs.

Install (2) HHCS 1/4-20 x 1 3/4", & (2) 1/4-20

nylock nuts (items #31, & 32) through 3" pulley

assemblies (items #8). Torque to 10 ft lbs.

WARNING:

Watercraft must float freely over bunks before lifting. The weight of

the watercraft must never be on the lift when it is in it's lowest

position. Failure to follow this procedure may result in severe

damage to your lift and/or watercraft and will void your warranty.

Sheet 7 of 8

Step 4