AME 24820 Gebrauchsanweisung & Teileliste - Seite 15

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung & Teileliste für Elektrowerkzeug AME 24820 herunter. AME 24820 18 Seiten. Automatic tire inflator 3 modes in one

Seite drucken

Each system and installation of Digital inflation

equipment is different however it is imperative with

any system that the drain valves (No.3) are opened

routinely to remove water that has been collected.

Immediately prior to the tire inflator (No.6) a regulator

(No.4) should be fitted. This should be set to 10 psi,

70 kPa or 0.7 bar above the maximum set pressure of

the unit. This will prevent excessive pressure being

supplied to the unit and the resulting error message

ER4. Refer to Section 4.0 Troubleshooting.

Also prior to the tire inflator a filter (No.4) should be

fitted. This filter should remove all solid materials

such as scale caused by corrosion inside the pipe

and reservoir. Contaminants may have an adverse

effect on the internal components of the system due

to blockage and corrosion.

AME INTERNATIONAL

INSTRUCTION MANUAL

& PARTS BREAKDOWN

- 15 -

WARNING

Ensure that the product is

connected to the correct power

and air supply, refer to rating

label and general specifications

CAUTION

If this equipment is being installed

on a retail petroleum site

consideration must be given to

the requirements of Australian

Standard AS/NZS2430.3 or the

relevant Hazardous Area

standard for your region.