Coast to Coast Coast Awning Wall Kits Handbuch - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Zubehör für Kraftfahrzeuge Coast to Coast Coast Awning Wall Kits herunter. Coast to Coast Coast Awning Wall Kits 8 Seiten. Coast awning wall kits
Seite drucken
Optional Extra—Step 2
Use the spike to make a hole for a stay-put in the 200mm
piece of loop Velcro, this should go through the side wall
material too (DO NOT use a drill)
The female part of the stay-put goes into the side wall,
press the male part (along with the loop Velcro) into it
Optional Extra—Step 1
Due to the projection of your awning and the position
of the track in your roller tube, there may be a gap
between the front wall and the side wall
If you would prefer that this is closed, we've included
a Velcro Stay-Put Kit. To fit this, you will need an
8mm spike and a pair of scissors
Optional Extra—Step 3
Now fit the 130mm piece of hook Velcro to the front
wall, the same method applies except that it will need
x2 stay-puts (positioned 30mm from each end)
Once this is done, simply attach the lose piece of loop
Velcro (from the side wall) onto the hook Velcro (on
the front wall) —no more gap!
Instructions for Press Studs:
Place a stainless steel screw (which you have pre-purchased)
through (C) - this is the receiver press stud
Screw the receiver press stud into the wall of your Caravan—Coast
recommends that you follow steps 1—9 as per the diagram for the
draught skirt and steps a –c for the wheel cover. Please use an
approved sealant behind each and every receiver press stud
Pierce a hole into the draught skirt material where you want the
cap stud to appear. Feed the shank of (A) through the hole in the
material and position on the disc supplied
Place (B) on the of shank (A). Holding the punch straight, hit sharp-
ly with a hammer to close/ set the two pieces firmly onto the
draught skirt material. (Diagram 1)
Press this onto the receiver stud (on your Caravan) - repeat the
process until the draught skirt is on
*Note: Depending on the length of your Caravan and depending on how
taught you want the draught skirt to be positioned, you may find that extra
press studs are required. Coast's recommendation as to press stud place-
ment is to be used as a guide only.