Coastal M-CBX9.6 2016 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Boot Coastal M-CBX9.6 2016 herunter. Coastal M-CBX9.6 2016 16 Seiten.

DISASSEMBLE AND DEFLATE BOAT

Remove the oars from both sides of the boat.

2. Deflate tubes about 50%.

3. Remove aluminum or air deck, reverse of install process. Deflate Keel.

4. Re-inflate tubes to 100% for cleaning. Clean inside and out.

5. Deflate bow tube first. The valves should be in their "open" position for

disassembly. They are open when they are in the down position. As the

bow tube is deflating, pull up on the bow ropes. This will make it easier to

fold later.

6. Deflate the main tubes. As they are deflating pull up on the side ropes so

that the boat will fold in properly

7. Fold both end tubes over transom. You want the tubes to fold in so the

entire package is not wider than the transom

8. Begin rolling up the boat from the transom.

9. Lay folded inflatable onto the storage bag and tighten the straps around

the boat being careful to make sure the storage bag covers the entire boat.

Proper care and maintenance greatly extends the life of your valuable boat.

During the season: Check the bottom regularly to make sure there is no

excessive build up of marine life. The surface of the boat should be cleaned with a

solution of mild soap and fresh water after each use when possible. To avoid

abrasion and wear, be sure that all the sand, small rocks, oil and dirt have been

flushed away from the boat surfaces, particularly the inside deck next to the tubes.

UV Radiation: The Number One Enemy of PVC Inflatable Boats. With this in

mind, we recommend that you cover your boat when it will not be in use for

extended periods of time. While we realize that it is not practical to cover your boat

every time you get out of it, if the boat is not going to be used for several days it is

advisable to cover it. Aurora Poly Guard, a UV Protectant should also be used to

help protect your boat from the sun. It helps to keep the boat looking like new.

Apply Poly Guard every 4 weeks to extend the life of your boat. Fuel Spills and

Engine Exhaust will damage the fabric of your Inflatable Boat.

IMPORTANT: Products never to use for cleaning your inflatable are: solvents,

MEK, toluene, acetone, bleach, ammonia, highly alkaline cleaners (anything with a

pH greater than11.5), abrasive scrub pads, steel wool. They will weaken damage

and discolor the fabric and attack the

your boat!

End of Season: It pays to remove dirt and other environmental contaminants

before storing it. Allow your boat to dry thoroughly in the shade before storing it.

adhesives.

Never use "Armor All®" on