aero pure AP100H-RVL Installationshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationshandbuch für Fan aero pure AP100H-RVL herunter. aero pure AP100H-RVL 13 Seiten. Recessed fan light
Seite drucken
PLAN THE INSTALLATION
1. Do not use in a cooking area.
ASSEMBLY INSTRUCTIONS
1. Before installation, you need to know:
Screw A
Screw B
Hanger bar
(long)
1. MOUNT WITH HANGER BARS
1a. Sliding hanger bars have been provided, which allow the housing to
be positioned accurately anywhere between the framing. The bars may be
used on all types of framing: I-joist, standard joist,
and truss construction. Slide hanger bars onto housing and adjust as
needed to fit between framing.
1b. Extend the hanger bars to the width of the framing. Position the
fan with the hanger bar tabs aligned with the bottom edge of the framing,
holding the ventilator in place.
Secure hanger bars to framing using one screw on each end of hanger bar.
Attach set screws to lock bar hangers in place.
2. INSTALL ROUND DUCTWORK
Connect the round ductwork (not included) to the damper/duct connector,
and run the ductwork to a roof or wall cap (not included). Using duct tape
(not included), secure all the ductwork connections so that they are air
tight. Insulated flexible duct is recommended for the quietest possible
installation. If rigid duct is used, a short (1-3 feet) section of insulated
flexible duct will ensure quiet operation
2. Two ways to connect ductwork to a factory-shipped unit.
ST4.2*1/2"
ST4.2*1"
13 3/8"
INSULATION*
(Place around and
over Fan Housing.)
FAN
POWER
HOUSING
CABLE*
Seal gaps
around
Housing.
ROUND
DUCT*
Seal duct
*
Purchase
joints with
tape.
separately
2
ROOF CAP*
(with built-in
damper)
Keep duct
runs short
WALL CAP*
(with built-in
ROUND
damper)
ELBOW(S) *
Screw A
Screw B