Canon 9318A001AA Vereinfachtes Servicehandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Vereinfachtes Servicehandbuch für Drucker Canon 9318A001AA herunter. Canon 9318A001AA 22 Seiten.
Seite drucken
3. ERROR DISPLAY
Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.
3-1. Operator Call Error (LED Blinking in Orange)
LED
blinking
2 times
Paper out
3 times
Paper jam
4 times
Ink tank not installed
5 times
Print head not installed or failure has
occurred in the print head.
(Non-supported print head (see page 4) is
installed or print head EEPROM data is
abnormal.)
8 times
Waste ink absorber full or platen waste ink
absorber full warning (approx. 95% of the
maximum capacity)
9 times
Non-supported digital camera or digital
video camera is connected.
3-2. Service Call Error (LED Blinking in Orange and Green Alternately)
LED
blinking
2 times
Carriage error
3 times
LF error
4 times
Purge unit error
5 times
ASF cam sensor error
6 times
Internal temperature error
7 times
Waste ink absorber full or
platen waste ink absorber
full
8 times
Print head temperature
rise error
9 times
EEPROM error
13 times
PF position error
14 times
PF cam sensor error
17 times
Motor driver error
Error
Error
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Replace the printer. (In waste ink absorber replacement, perform
the EEPROM information print to identify if the main and/or platen
waste ink absorber should be replaced. After replacement, reset
the applicable waste ink counter(s).)
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Turn the printer off and on again. If the error is not resolved,
replace the printer.
Corrective action
Set paper, and press the Resume/Cancel button
to feed the paper.
Remove the jammed paper, and press the
Resume/Cancel button.
Re-install the ink tanks, and close the front cover.
After confirming that the print head is for the
iP2000 (QY6-0054), re-install the print head, and
close the front cover.
If not recovered, with the print head installed,
power the printer off and on.
Pressing the Resume/Cancel button will exit the
error, and enable printing.
After removing the cable between the printer and
the camera, press the Resume/Cancel button, and
re-connect the cable. If the error is not resolved,
the connected camera may not be supported for
Camera Direct Printing. Check that a supported
camera is connected.
Corrective Action
5