aero-naut Princess Anleitung Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Spielzeug aero-naut Princess herunter. aero-naut Princess 17 Seiten. 3081/00
Seite drucken
29
27
21
Break off the jig tabs from the keel 12 and the
frames 1 - 11, and sand away any rough
edges. Remove the plywood template 18.
All the hull components should now be sealed
with three coats of clear waterproof lacquer on
the inside, to ensure that the interior of the
hull is waterproof. Do not paint the top edges
to which the deck is to be glued.
Motor
30.5
28
29
Motor
30
19
The boatstand can now be
assembled: glue parts 27, 28 + 29
together in pairs, and glue these
assemblies to the bearers 29 when
Motor
7
30.5
23
Slip the propeller shaft and shaft tube 30 into the hull, and connect
the shaft to the motor shaft using the coupling sleeve 30.5 or 30.6;
check that the propeller rotates freely.
Seal the outside end of the shaft tube 30 with adhesive tape before
gluing the shaft tube to the rear keel 14 and the bottom panels on
the inside of the hull using two-pack adhesive.
20
The finished boatstand.
From this point on the hull should be left in
the stand for all construction work.
30.5/30.6
30
Fix the electric motor to the motor bulkhead
(frame 7) using the screws and washers
supplied. Oil the sintered bushes in the
shaft tube 30.
30
22