Coaster 900723 Montageanleitung Handbuch

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Uhr Coaster 900723 herunter. Coaster 900723 10 Seiten. Grandfather clock

Seite drucken

900723

ITEM:

Regarding the timekeeping troubleshooting methods:

STEP 10

Your clock is fitted with a Westminster Chiming movement. This has an automatic night silence function that silences the

STEP 7-1

NOTES: PLEASE MAKE SURE CLOCK IS IN LEVEL POSITION, OTHERWISE

SETTING INSTRUCTIONS

1.Solution for not reporting the time with chime:

Chimes between 10.00 P.M. and 5.00 A.M.(last strike 9:00PM, first strike 6:00AM).

IT WILL NOT OPERATE PROPERLY.

Before the clock leaves the factory, the clock has been set at 5:55AM.

a.Rotate the volume button (

ATTENTION: ANTI TIPPING SAFEGUARD

Do not mix Old and New batteries. Do not mix Alkaline, and Standard(Carbon - Zinc) or

Please make sure you have 2 x C and 3 x AA Alkaline batteries, as these are not included. You will also need a screwdriver.

Before setting time, chime and pendulum, please open the

STEP 4-1

STEP 1-1

Rechargeable(Nickel - Cadmium) batteries.

b.Check whether the positive and negative positions of the battery are correct (

ALKALINE BATTERIES REQUIRED

BACK OF THE CLOCK

back panel on the Top Unit. After removing the cover,

SIZE C

is inaccurate, please reinstall it according to the icon.

please refer to the figure at the right to identify and locate

2 PCS

c.If the positive and negative poles of the battery are correct and the problem is still not

the following items:

ASSEMBLY TIPS:

resolved, adjust the time to 5:55 clockwise by Hand Set Knob, remove the battery, wait for

Here are a few symptoms that are associated with 'Defective Batteries' or 'Incorrect Installation'

1. Remove hardware from box and sort by size.

a while, and place it again. Then adjust the clock hands to 6:00 to tell the time and music.

■ Clock Section

and do not indicate that the clock itself is defective:

2. Please check to see that all hardware and parts are present prior to start of assembly.

3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.

■ Clock Battery Chamber

d.Or use the Red button on the Chime box (

Warning!

If the positive and negative poles of any battery are reversed, they must be removed first and then

■ Chime Section

you press, no more than 8 times, you can hear the time and music. The time signaling this

1. Don't attempt to repair or modify patrs that are broken or defective. Please contact the store immediatelly.

installed again. All are taken down to initialize the clock. Then install it correctly. It is not possible

FURNITURE TIPPING RESTRAINT

■ Chime Battery Chamber

2.This product is for home use only and not intended for commercial establishments.

time is 6:00 AM. And then, press the red button to match the clock time. After that turn

to mix an old battery with a new battery, let alone replace it with another type of battery. Be sure

■ Pendulum Section

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

Hand Set Knob to adjust the clock hands clockwise to the actual local time.

to use 3pcs of AA size and 2pcs of C size batteries. A bad battery can also cause the clock to work

■ Pendulum Battery Chamber

STEP 5

infrequently.

2.The clock telling time is inconsistent with the displayed time. It can be adjusted by the Red

button (

2) on the Chime box. Each time you press it, an hour will be added, and so on.

Figure

SETTING TIME AND CHIME

STEP 8

STEP 2-1

Possible conditions of the clock caused by insuﬀicient battery power: Inaccurate time reporting,

This restraint is not a substitute for proper adult supervision.

short chain

Note that the Red key is after 12 o'clock, and it is 1:00 when you press it again.

random time reporting, always reporting one time. Or the volume of timekeeping and music is

This restraint may provide protection against tipping furniture.

long chain

3.The hourly timekeeping time is inconsistent with the displayed time. Please set the clock to

getting weaker and weaker. If the battery is low, it will leak, and corrode the metal circuit and cause

1. if it is not at 5:55, turn clock hands to 5:55 by Hand Set Knob(Figure 1).

PART NAME

the clock to malfunction. Even damage the battery box. If any of the above problems are found,

5:55 without placing the battery (

Make sure the hands move CLOCKWISE ONLY.

weight

Failure to detach this restraint before moving furniture may

replace the battery in time.

2. Insert 2 x AA Batteries as shown (Figure 2). Ensure that the positive

go to 6:00, and the clock will show time as 6:00 AM.

TOP UNIT

(+) and negative (-) symbols are aligned as shown.

4.The time is not reported at 10 o'clock during the day, but reported 10 o'clock at night. The

Regarding the operating troubleshooting methods:

main reason is that the clock defaults to night as day. You can press the Red (

pendulum

1. When you assemble the clock, you should be careful to avoid touching the pointer and each line

FRONT DOOR

on the Chime box for 12 times to change the time from day to night.

Clock

1.Insert 2 x C Batteries into the Pendulum Battery

to prevent the clock hands from shifting and the line loose.

Section

5.If the clock reported with other chime or strike only or 'Westminster' chime only in full hours,

Chamber.Ensure that the positive and negative

LEFT SIDE

symbols are aligned as shown.

please set the correct chiming sequence 3. See picture 2 at PAGE 7.

QUARTZ

2. (Figure 1) When turn the clock hands by Hand Set Knob counterclockwise, Do not let minute

PANEL

2.Push Pendulum Hanger lightly,to release the

STEP 6

hand past the 12 o'clock position, otherwise it will damage the timekeeping contacts of the

STEP 9

Pendulum Hanger from "Pendulum Hanger Shipping

movement, resulting in failures such as no timekeeping or no music.)

Regarding pendulum troubleshooting methods:

STEP 3

RIGHT SIDE

Retainer", and to allow Pendulum to swing freely.

ＳＩＺＥ　ＡＡ

PANEL

1.If the swing range of the rocker is small or does not swing, the general situation is that the

3. Hang the Pendulum (H) as shown in the figure

3. Before the clock leaves the factory, the hour hands have been set at 5:55AM. If the clock display

below.Make sure that the bright side of the Pendulum

is not this time, please turn the minute hand by Hand Set Knob clockwise to adjust to 5:55AM,

battery power is insuﬀicient, or the connection line between the rocker and the battery box

FIGURE 1

Bob fces te front of the clock.

and then insert the battery.

BACK PANEL

is poor, and you need to replace new batteries or reinsert it and confirm whether it is secure.

4. Hang the Decorative Weight (I) as in the figure

2.If the swing range of the pendulum is unstable, or it shakes, etc. In addition to the battery

below.

4. The first chime is set to 6:00 AM. The chime will stop automatically from 10:00 PM to 5:00 AM.

E.g.-if you are setting the clock to 8 o'clock in the evening,8:00 pm,you will need to move the hands

5. Lightly push the Pendulum (H) sideways to let it

power attenuation, it is usually caused by the hook of the pendulum not hanging to the

(The night stop function is programmed before leaving the factory. The user cannot change it)

forward to 12 o'clock and then continue to 8 o'clock to show 8:00 pm. Alternatively, if the time is 8:00

swing.

DESCRIPTION

am when you are setting,you just move the hands forward from 8:00 to 8:00. The clock now knows it

middle position of the pendulum rod. See (The 3 sentence of paragraph 1), and make sure

is 8:00 am.

5. Once the battery is removed, the chime box will be automatically initialized. After reloading, it

BOLTφ8*40mm

that the pendulum plate and the clock body are parallel. Don't deviate, twist, etc. and you

IMPORTANT NOTICE: PLEASE MAKE SURE THE

If the clock time is not right or the clock chimes incorrectly,please replace the batteries,and follow

will be reported again from 6:00 in the morning. (Figure 2)

PENDULUM HANGER" IS RELEASED FROM THE

need to manually push the pendulum plate to the left or right, so that the pendulum plate

FIXING BARS

the set time and chime procedure as above.

"PENDULUM HANGER SHIPPING RETAINER",

Your clock will not chime or strike after 9:00 pm,It has an AUTOMATIC night mute with the last strike

does not touch the inner wall of the clock case. The pendulum will swing normally.

CABLE TIE

OTHERWISE THE PENDULUM WILL NOT SWING.

at 9:00 pm and the first at 6:00 am.

REVISION 3: 07/12/2022

CAUTION

2) to the maximum position.

Figure

ASSEMBLY INSTRUCTIONS

COASTER FINE FURNITURE

SIZE AA

TROUBLESHOOTING

3 PCS

WARNING

ASSEMBLY TIME PER UNIT:

Injury may result from tipping furniture.

PARTS IDENTIFICATION

Do not allow children to climb on furmiture.

FIGURE

Figure

Ⅻ

result in injury and damage.

①

PENDULUM INSTRUCTION

3. Insert 1 x AA Battery into the

Clock Battery Chamber (Figure

1).Ensure the positive (+) and

negative (-) symbols are aligned as

shown.

4. Press the Red 'Set' Button once

to start the chiming sequence.

Hand Set

5. Your clock will play the 'Westminster' chime and 'strike' six

Knob

times indicating 6:00am.Your clock is now set to the correct

chiming sequence 3 (Figure 2).

Clock Battery

6. After setting the correct chiming sequence,then set the clock to

Chamber

the correct time with the Hand Set Knob.

HARDWARE IDENTIFICATION

①

②

FIGURE

STEP 7-2

STEP 4-2

STEP 1-2

ｈｏｌｅ

ASSEMBLY TOOLS REQUIRED

⑥

ｈｏｏｋ

③

√

①

2) to solve problem as (c.) above, each time

Figure

STEP 2-2

QTY

PART NAME

1). After placing the battery, manually automatically

1PC

BASE UNIT

TOP

1PC

DECORATION

PENDULUM

1PC

DECORATION

1PC

WEIGHTS

DECORATION

1PC

CHAINS

QTY

DESCRIPTION

8PCS

LONG SCREW

Grandfather Clock

2PCS

SHORT SCREW

1PC

PLASTIC ANCHOR

PAGE 10 OF 10

PAGE 2 OF 10

PAGE 3 OF 10

PAGE 8 OF 10

PAGE 4 OF 10

PAGE 5 OF 10

PAGE 9 OF 10

PAGE 7 OF 10

PAGE 6 OF 10

PAGE 1 OF 10

Ⅻ

ｓｐｅａｋｅｒ

ｓｅｃｔｉｏｎ

④

Ｃｌｏｃｋ

Ｓｅｃｔｉｏｎ

ＱＵＡＲＴＺ

ＳＩＺＥ　ＡＡ

①

Ｐｅｎｄｕｌｕｍ

Ｓｅｃｔｉｏｎ

20 MINUTES

BY 2 PERSONS

Switch

①

Volume

FIGURE

Control

chime

section

1 2 3 4

①

Figure

ＳＩＺＥ　ＡＡ

Pendulum Battery Chamber

ＳＩＺＥ　ＡＡ

FIGURE 2

Ｐｅｎｄｕｌｕｍ

Ｓｅｃｔｉｏｎ

①

Fine Furniture for every stage of life

FIGURE

900723

Pendulum Hanger

Pendulum Hanger Shipping

Retainer(Push to release Pendulum)

COASTERFURNITURE.COM

④

③

2). If it

Figure

⑤

ｃｈｉｍｅ

ｓｅｃｔｉｏｎ

ＳＥＴ

1 2 3 4

ＳＩＺＥ　ＡＡ

Chime Battery

Chamber

Clock Battery

Chamber

Red"Set"

button

QTY

ＳＥＴ

1PC

2) button

1PC

Chime Battery

Chamber

2PCS

4PCS

QTY

1PC