Aktobis WDH-416S Schnellstart-Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Luftentfeuchter Aktobis WDH-416S herunter. Aktobis WDH-416S 9 Seiten.

Directions for use:

1. Commissioning

1.1 Insert the power plug properly into the power outlet.

1.2. Check that the condensation tank is properly seated in the dehumidifier. (When using the dehumidifier for the

first time, it is possible that the "condensation tank full" light is illuminated. Simply pull the condensation tank

out briefly and then push it right back in again and you are ready to go! )

1.3 Switch on the device with the operating switch (on/off button). Now press the humidity setting button and set

your target humidity as desired. The target value "CNT" corresponds to continuous operation ! The value you

set must be below the current room humidity for the unit to dehumidify. If your value is above the current room

humidity, the fan runs for 3 minutes and the unit then switches off. If the room humidity rises above the set

value, the device automatically starts dehumidification operation again.

1.4 Use the air circulation adjustment button to select between low and high fan speed / air circulation.

1.5 If you want to activate/use the timer function (function for determining the remaining time or function for

specifying a start time), press the TIMER button.

Determining the remaining run time: Press the TIMER button during operation to select the desired remaining

run time of the dehumidifier. (A value between 1 - 24 hours can be selected). After this selected operating time

has elapsed, the device switches off automatically.

Determining a start time: When the dehumidifier is switched off, press the TIMER button to select the desired

start time. (A value between 1 - 24 hours can be selected). After this selected time has elapsed, the appliance

switches on automatically (with the last settings used, provided the mains plug has not been disconnected in

the meantime).

1.6 If you want to use the laundry drying mode, press the button to activate the laundry drying mode. In the laundry

drying mode, the air circulation is continuously set to high.dehumidified. The appliance operates in continuous

mode here. Exit the laundry drying mode by pressing

pressing the button again to activate the laundry drying mode.

1.7 In the air circulation mode ( air purification ) only the fan operates and no dehumidification takes place.

Start and stop this setting, by pressing the button to activate the

Air circulation mode (air purification).

2. Emptying the collection tank / When the "Condensation tank full" light is on

When the condensation tank is full, the signal light comes on and the dehumidifier then

automatically stops its dehumidification operation. Remove the condensation tank and empty

it. After you have pushed the condensation tank neatly back into the device, the

dehumidification operation starts again automatically.

3. Connecting a hose

3.1. You will need a ½ inch plastic hose.

3.2. Remove the condensation tank for a short time.

3.3. Pass the plastic hose through the opening above the condensation tank and then connect it to the drip tap (see

diagrams below). Then push the condensation tank neatly back into the appliance.

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de