12-Voltair 12V6CF Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Luftkompressor 12-Voltair 12V6CF herunter. 12-Voltair 12V6CF 16 Seiten. 150 psi 6 cfm

Seite drucken

1. Picture Diagram

FIN DINg A LO CATIO N

In finding a location for your compressor...

1. Find a location in which the 12-Voltair can get adequate ventilation.

2. Find a location in which the 12-Voltair will not be overly exposed to dirt and dust.

3. Find a location in which the 12-Voltair can be properly fastened to ensure that it does not shift.

4. Check the underside to make sure that any drilling of holes will not interfere with existing lines or structure.

Once you have decided on a location for the 12-Voltair...

1) Set the unit into position

2) Mark the 3 holes on the right side of the compressor base

onto the floor of your location.

3) Mark the 4 mounting holes of the base of the 12-Voltair on

the floor of your location

4) Set the unit aside and get ready to drill some holes

se gOOd COmmON seNse wheN INsTAllINg The

leCTrICAl ANd plUmbINg

HoW BIG oF A Hole SHoUld I dRIll? To eliminate any potential problems,

Voltair recommends adding extra protection around the wires and hose (such

as running the wires and hose through another hose, or use a rubber grommet).

However you decide, drill a hole at least 1/8" bigger than the outside diameter

of the hose/wires that will be run through the floor of your location.

5) Drill your holes

- 3/8" hole for 5/16" x 1 1/2" mounting bolts

- holes for electrical and plumbing

6) Once your holes are drilled, move the 12-Voltair back into position

and use the provided 5/16" x 1 1/2" bolts, lock washer and nut to

secure it to the floor. If possible also drill through the side of the

12-Voltair cabinet to secure it at a higher point.

a) Deck Mount- use all 4 mounting holes in base of the 12-

Voltair frame.

b) Bed Side Mount- use at least 2 of the for mounting

holes on the base of the 12-Voltair as well as 2

holes higher up on the back of cabinet as shown in the

above diagram.

Once the 12-Voltair is securely fastened to the vehicle go to next page.

"A ir W here A nd Wh e n Yo u N e e d I t ! "

CAUTION:

12-V

be sUre TO CheCk The UNdersIde TO mAke sUre yOUr drIll wIll NOT INTerfere

Or dAmAge exIsTINg lINes

. w

OlTAIr

heN drIllINg hOles fOr mOUNTINg

hOses Or sTrUCTUre

Here is an example of securing the cabinet 'at a

higher point' for a bed side mount

Mounting Holes

ground Wire

Air Line

Positive Wire

Here is an example of

protecting wires by either

using 'another hose' or

'rubber grommet.'

Page