AMERICAN SPORTSWORKS 15184 Einbauanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Einbauanleitung für Zubehör für Kraftfahrzeuge AMERICAN SPORTSWORKS 15184 herunter. AMERICAN SPORTSWORKS 15184 4 Seiten.
Seite drucken
Front of Vehicle
Fig. 4
3
Winch Wiring Preparation (figures 4 & 5)
• Using the 3/8" Drill and 1" Flat Bit, (2) 1" holes will need to be drilled on
the unit in order to install the winch.
• Hole #1 is to be drilled on the seat tub surround towards the center and
near the floor. This hole will allow the winch controller to be mounted on
the surround and allow the excess wire to be stored inside the storage tub.
• Hole #2 is to be drilled on the rear backsplash just above the battery and
will create access for the winch power from the battery.
Behind Drivers
Seat
Hole #2
Fig. 5
4
Winch Wiring Installation (figures 3, 4 & 5)
• Lay out the wiring harness such that the leads can be easily identified by
length prior to installation.
• Place unit on properly rated jackstands or automotive ramps to allow
access to the underbody channel. Secure vehicle with wheel chock and
parking brake before attempting to work under the unit.
• Feed all wires from the outside into the seat tub storage area thru Hole #1.
Once installed, the winch control should be resting on the floor of the unit.
• Feed all wires from inside the seat tub storage area thru Hole #2 in the rear
backsplash. This will allow wire access to the battery connection and
forward feed to the front mounted winch (refer to figure 3).
• Carefully route the long black and red pair of wires through the underbody
channel to the front of the vehicle (refer to figure 5).
Hole #1 in
Tub Surround
Fig. 6
Winch to
Battery
Connection
Fig. 7
Front of Vehicle
Use caution to ensure that the wire insulation does
not become damaged when feeding through the
NOTE
channel. Bare wires will ground to the frame and
cause shorting or possible damage to the battery.
• Leave approximately 16" of wire at the front of the vehicle to allow
adequate slack for attachment to the winch
5
Final Connections
• At the front mounted winch, connect the RED wire to the (+) terminal on
the winch using. Ensure that the connection is tight and
that the supplied protective rubber terminal cover is installed. Repeat this
process with the BLACK wire and the (-) terminal on the winch.
• Remove any excess slack from the lead wires by shifting towards the rear
of the vehicle within the underbody channel. Use care to ensure that
insulation does not become damaged or pinched.
• At the back of the vehicle, connect the RED wire to the (+) battery terminal
as indicated on the battery casing.
• Connect the BLACK wire to the (-) battery terminal as indicated on the battery
casing.
• Slack left in the storage tub should be covered in factory loom, any excess
wire outside of the loom should be pulled through Hole #2 and neatly tied
to the frame using the supplied tie wraps.
• Using the supplied adhesive backed hook & loop material, attach winch
control to seat tub.
16" Lead Wire
to Winch
Hand Held
Winch Controller
Underbody Channel
Page 2 of 4
15200 Rev. B