Bobot DPS 120 Gebrauchsanweisung - Seite 15

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Staubsauger Bobot DPS 120 herunter. Bobot DPS 120 16 Seiten.

Seite drucken

Daily cleaning and

maintenance

1. Turn off the power and remove the electric floor brush;

2. Press the roll brush release button, the side roll brush cover plate will pop open

and unlock;

3. Turn the roller cover clockwise and pull out the roller together;

4. Remove the winding and garbage on the roller;

5. Push one end of the clean (or brand-new) roller connecting the shaft into the

electric floor brush first, and then press the cover plate of the roller brush，turn

clockwise and lock.

6.4 Removal of foreign matter blockage

When the air duct is blocked, the indicator will light up, then the machine switches

into low gear mode. Meanwhile, please turn down the power, and check the air

duct, remove the blockage, and then use it again.

Remove the foreign matter blocked by the floor brush: refer to "cleaning the

roller brush".

Remove the foreign matter blocking the extension tube, dissemble the

extension tube, check and dredge it, and then replace it.

6.5 Disassembly and replacement of battery pack

1.Turn off the power, press the release button at the bottom of the battery pack, and

take out the battery pack.

2.Align the new battery pack with the battery card slot of the hand-held vacuum

cleaner, then insert it and snap it in place.

Note:

This vacuum cleaner must use the original battery pack and power adapter.

Do not use the battery pack for any purpose other than this vacuum cleaner.

BOBOT ROBOTICS INC.

Simple faults and

handling methods

7. imple faults and handling methods

W a r n i n g : i n c a s e o f a b n o r m a l o p e r a t i o n o f t h e

v a c u u m c l e a n e r , p l e a s e t u r n o f f t h e v a c u u m

Fault

Possible causes

phenomenon

Vacuum cleaner

Low battery

fails to start

Dust collecting cup full

The extension tube or floor

The vacuum

brush is blocked by foreign

cleaner has no

matters

Dust collecting cup or

or small suction

separation filter not

installed correctly

Dust collecting cup full

There is obvious

dust leakage from

Dust collecting cup or

the vacuum cleaner

separation filter not

installed correctly

The roller brush is twisted

The rolling brush

or stuck, and the protection

stops rotating

device is started

Insufficient charging time

Shorter use time

after charging

Battery aging

Warning: If the above prompt still cannot solve the machine problem,

please contact our after-sales service or technical personnel Contact, do

not disassemble and repair by yourself!

BOBOT ROBOTICS INC.

Processing method

Refer to the manual "battery

charging" for correct charging

Empty dust

Refer to the manual "removal of

foreign matter blockage"

Reinstall the dust collection cup

or separation filter correctly

Empty the garbage in the dust

collecting cup