Bobot SOP 610 Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Staubsauger Bobot SOP 610 herunter. Bobot SOP 610 8 Seiten.

Seite drucken
Bobot SOP 610 Gebrauchsanweisung
Machine Translated by Google

Product use

5.2 When using the hand-held vacuum cleaner

Press the power button on the top of the fuselage, press the power button for the first time to enter the low-level vacuuming work, and the battery indicator light at the rear of
the fuselage lights up; press it again to enter the high-end vacuuming work; press the third time to stop
Warning: Do not immerse the entire mop head in the sink for cleaning!
Do not use the whole machine to directly absorb water!
The battery can be disassembled and charged separately, or it can be charged on the fuselage;
after the vacuuming work is completed, you can press the left and right release buttons on the front of the dust cup to
remove the dust cup, take out the filter assembly, and dump the garbage, the dust cup and filter can be Rinse with
clean water.
Note: If the filter is rinsed with water, the HEAP must be dried/dried/dried before being put back into the machine.
Continued use to avoid water inhalation and damage to the machine.
BOBOT ROBOTICS INC.
working.
8
Product use

5.3 When the vacuum cleaner + double disc is used in combination

Press LO and HI on the handle alone to control the vacuum cleaner to enter the low-grade and high-grade working modes, the battery power indicator lights up, and
the marquee lights on both sides of the front of the mop flash, press the button again to stop working; tilt the body to a suitable position Angle, press the MOP button
to start the double roulette work, automatically spray water to pre-wet the mop, press the MOP button again to stop the double roulette work; press the trigger on the
handle, the water spray indicator of the clean water box will light up, and water will be sprayed to the mop.

5.4 When the machine is low or dead

Plug the charger into the charging jack on the battery pack to charge, there are four LED lights to display the charging
status, the power
The LED light flashes to indicate continuous charging, the four LED lights light up at the same time to indicate that it is
fully charged, and all LEDs are fully charged off.

5.5 Assembly, disassembly and cleaning of the double wheel mop

When installing the mop, just stick the velcro on the centering wheel of the mop; after work, tear off the mop for cleaning or use a self-cleaning basin
for
cleaning.
BOBOT ROBOTICS INC.
middle.
Note: Do not use the machine to clean
cleaning may cause malfunction.
9