euro verbau EG PV 4000 Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Baumaschinen euro verbau EG PV 4000 herunter. euro verbau EG PV 4000 4 Seiten. Corner slide rail system

Seite drucken

©2012 EUROVERBAU • Die hier veröffentlichten Inhalte sind urheberrechtlich geschützt. Der Inhalt darf ohne schriftliche Genehmigung der Herausgeber weder bearbeitet, übersetzt, vervielfältigt oder verbreitet werden.

M NU L

CORNER SLIDE RAIL SYSTEM

f) If the plate head has reached the upper edge of the pit, in-

sert a second plate into the inner guide of the corner slide

rail if necessary, as far as the height of the blade of the first

plate. Press in the inner plate further, as described in e) If

necessary, slide support plates into the outer slide-rail guide

and connect them to the lower plate by means of locking

bolts and safety clips.

g) When the excavation is finished, the plate head should lie

approx. 10 cm above the base and serve as a scree pro-

tector.

6. Dismantling

a) Insert the backfill material in layers (observing the compac-

tion level).

b) Pull out the plates and corner slide rails up to the filled

area. In doing so, start from the inner plate. The height of

the respective pullout is according to compaction level.

c) Compact the backfill material.

d) Restart at point 6.a, until the shoring iscompletely pulled

out of the earth.

7. Disassembly

Before transporting away the shoring unit, it is disassembled

analogously to the assembly but in the reverse sequence.

8. Maintenance / Service

On each disassembly, the corner rails should be cleaned. The

entire shoring unit must be protected against corrosion cau-

sed by handling damage by the use of appropriate protective

measures.

9. Transport

When unloading, you should store the supplied wooden

blocks and the rubber plates appropriately. These parts must

always be re-used for the return transport. As the shipper, you

are co-responsible for the appropriate shipping of the return

transport.

EG-CORNER / DG-CORNER

Manufacturer Certification in Compliance

with DIN EN 1090-2

rench shoring equipment

Production - Sales - Rental - Service

2012A