BobsCNC E3 Handbuch zur Fehlersuche - Seite 9
Blättern Sie online oder laden Sie pdf Handbuch zur Fehlersuche für Graveur BobsCNC E3 herunter. BobsCNC E3 16 Seiten. Cnc router engraver bearing and rail dust kit
Auch für BobsCNC E3: Handbuch (8 seiten), Schnellstart-Handbuch (3 seiten)
Seite drucken
- 1. Table of Contents
- 2. My Stepper Motors Are Running Backward
- 3. My Z Axis Is Not Homing Correctly
- 4. My E3 will Not Home Correctly (Diagnosing Home Switches)
- 5. My Firmware Does Not Seem to be Working
- 6. I Tried to Use Easel, Now My Machine Does Not Work Correctly
- 7. I Get and Error When I Run a G-Code File Made with F-Engrave
- 8. My Z Stepper Motor Wobbles Excessively
- 9. My Machine Seems to be Skipping some Commands
- 10. What Are the Alarm Code Descriptions
- 11. How Do I Change My Current Setting on the Stepper Motor Drivers
- 11. Setting the Current on the A4899 Stepper Motor Driver with a Volt Meter
- 11. Setting the Current on the A4899 Stepper Motor Driver Without a Volt Meter
- 12. The Dewalt Motor Shaft Came out During Assembly. (Dewalt Brush Remove and Replace)
Setting the current on the A4899 stepper motor driver with a volt meter.
The current on the A4988 stepper drivers can be set easily with a volt-meter. The driver is setup to set a
reference voltage (volts) that determines the current (amps) to drive the stepper motors. First, we will
need to determine the correct current and resistor readings. The typical resistor values for the stepper
driver are 0.2, 0.1, 0.05 ohms, 2 of which are shown below.
Once we know the resistor value we can calculate the resistance we need by using the formula
= ∗ 8 ∗ or = /(8 ∗ )
For the E3 CNC router we want the current to be around 0.9 amps. The settings would be as follows:
We can set the voltage by holding the negative led to ground and the positive lead to the potentiometer
as shown below. To turn the current up, turn clockwise. To turn the current down, turn counter