DOMPEL SILVER Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Outdoor-Wagen DOMPEL SILVER herunter. DOMPEL SILVER 6 Seiten. Trolley

Seite drucken
ENGLISH

location of installation

Install your Dompel product in a level place with no grooves or splices,
preventing rocking and vibration. The location must be airy and it must not
allow straight sunlight and it must be away from sources of heat (stoves,
ovens, etc.) and flammable products. Do not install your product outdoors.
cleaning and maintenance
Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach,
thinner, solvents, varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes.
To easily clean it, use a solution of warm water with a neutral soap and then wipe dry carefully. The plastic parts
can not be washed with boiling water. Chromed metal components can be cleaned with a soft, dry flannel, and
silicone-based automotive wax can be used to increase gloss and durability, in this case perform the task following
the wax manufacturer's instructions. Perform periodic cleaning, accumulated dust affects the beauty of the product
making it difficult to clean the product.
IMPORTANT
Never drag the product, if necessary, ask other person's help to remove the product from the place. Do
not place containers with high temperature on your product, at the risk of damaging plastic parts or the
upholstery.

INSTALLATION AND ASSEMBLY

Remove all the products from the package and follow the steps below
1
Manually fit the casters (B) into the base of
the assembled structure (A) with access at
the bottom. Make sure they are well fitted and
aligned when resting on the floor.
3
Manually fit the accessory holder (D) on one
of the sides of the assembled structure's top
(A). Note: press until you notice the complete
fixation of the lower brackets on the top. The
holder can be assembled on both sides.
5
Merely illustrative images.
Products may suffer changes in its components without prior warning. If any questions, contact Dompel.
2
Manually assemble the metallic tray (C) on the
top of the assembled structure (A). Take the
opportunity to test the retractable movement
of the hair dryer holder with access from the
bottom of the top.
4
Manually fit the drawers (E) on the rails
of the assembled structure modules (A).
Fitting, moving and accessing the drawers
will take place on both sides of the trolley.
Removable drawers (E) can be
manually coupled to the sides of
the top to expand the work space
as needed.
Important! To ensure safety
and prevent damage to the
product, distribute the weight
evenly over the support areas
and avoid long journeys on
uneven ground with maximum
load.
security
Avoid accidents. After
unpacking the product, keep
all the pack material out of
children's reach.