American Standard Lakeland SERIES 7193 Einbauanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Einbauanleitung für Inneneinrichtung American Standard Lakeland SERIES 7193 herunter. American Standard Lakeland SERIES 7193 4 Seiten. American standard kitchen sink installation instructions

Seite drucken

INSTRUCTIONS FOR UNDERCOUNTER MOUNTED SINK

WITH SINK TOP MOUNTED FAUCET.

Drill a clearance

hole inside the

cutout line as

marked on the

countertop.

Cut opening on cut line inside the perimeter of the template.

Note - Formica

countertop installation

only is illustrated. Contact

your countertop

distributor for the best

method of cutting other

materials such as marble,

hard synthetics, etc.

Attach at least eight of the support clips to the underside

of the countertop as shown below. The location of the

clips should be as shown in the sink diagram. The wood

screws are for use in wood, plywood, or particle board

(drill appropriate pilot hole). The inserts supplied are for

use in marble or hard synthetic material.

Apply a bead of sealant to

the edge of the sink. Hold

the sink against the

under-side of the

countertop and rotate the

clips to hold the sink in

place. Snug the screws to

hold the sink. Attach all

the additional clips.

Mount the faucet and drain

assembly on the sink or

countertop following the

manufacturer's instructions.

Connect supply lines to

faucet finger tight, and

carefully bend to

engage with the supply

stops.Tighten

connections to faucet for

secure seal.

7 9 1 3 9 3 - 1 0 0 R e v . A

Countertop

Perimeter

of sink

Cutout

Countertop

Perimeter

of sink

Cutout

CUTOUT

SUPPORT

CLIPS

Countertop

12mm

(1/2")

Support Clip

Countertop

Sink

Surface

Countertop

Sink Surface

Under counter

Connect drain assembly hand tight to check alignment. It

may be necessary to cut off part of the tailpiece (area "A") or

part of the horizontal leg of the trap (area "B").

Secure joint for watertight assembly.

CARE AND CLEANING...

For all porcelain enamel surfaces, regular, gentle care is best. The

recommended way to preserve the finish, avoid scratches, and clean

porcelain enamel fixtures is to rinse them with detergent and water.

Generally, any of the light duty liquid dishwashing detergents, such as

Palmolive or Dawn, work well. In areas where the water is hard, a heavy duty

liquid laundry detergent such as liquid Tide will work better.

Product names listed herein are trademarks of American Standard Inc.unless otherwise noted.

Palmolive ® is a registered trademark of Colgate-Palmolive Co.

Tide ® and Dawn ® are registered trademarks of Procter and Gamble.

AMERICAST ® LIMITED LIFETIME WARRANTY

If an American-Standard Americast® brand product is found to be defective in

materials or workmanship, after inspection by an authorized American-Standard

representative, American-Standard will repair or, at its option, exchange the product

for a similar model. This warranty extends for the lifetime of the product, so long as it

remains in use in its original place of installation, except that the warranty applies to

a bathing vessel's slip-resisting surface only for the first year after the product's initial

installation.

This warranty applies only to the original purchaser and installation of these

products.

This warranty does not apply to whirlpool components or to faucets, drains,

mounting rims, grab bars or other accessories. If manufactured or supplied by

American-Standard, such whirlpool components and accessories are covered under

separate limited warranties.

Cutout

This warranty does not apply to local building code compliance. Since local

Edge

building codes vary considerably, the purchaser of this product should check with a

local building or plumbing contractor to assure local code compliance before

Sealant

installation.

This warranty shall be void if the Americast® brand product has been moved

from its initial place of installation; if it has been subjected to faulty maintenance,

abuse, misuse, accident or other damage; if it was not installed in accordance with

American-Standard's instructions; or if it was modified in a manner inconsistent with

the product as shipped by American-Standard.

American-Standard's option to repair or exchange the product under this

warranty does not cover any labor or other costs of removal or installation, nor shall

American-Standard be responsible for any other incidental or consequential

damages attributable to a product defect or to the repair or exchange of a

defective product, all of which are expressly excluded from this warranty.

(Some states or provinces do not allow the exclusion or limitation of implied

warranties, so this exclusion may not apply to you.)

This warranty gives you specific legal rights. You may have other statutory rights that

vary from state to state or from province to province, in which case this warranty

does not affect such statutory rights.

For service under these warranties, it is suggested that a claim be made through

the contractor or dealer from or through whom the product was purchased, or that a

service request (including a description of the product model and of the defect) be

sent to the following address:

Attention: Director of Consumer Affairs

For residents of the United States, warranty

information may also be obtained by calling

the following toll free number: (800) 442-1902

In Canada:

American Standard

2480 Stanfield Rd.

Mississauga, Ontario

Canada L4Y 1S2

Toll Free: (800) 387-0369

www.AmericanStandard.ca

Trap

Single Bowl

In the United States:

American Standard Inc.

P.O. Box 6820

Piscataway, New Jersey 08855

www.AmericanStandard-US.com

In Mexico:

Customer Service Manager

Ideal Standard, S.A. de C.V.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico