American Standard RENAISSANCE EL TOTAL 2446 Einbauanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Einbauanleitung für Inneneinrichtung American Standard RENAISSANCE EL TOTAL 2446 herunter. American Standard RENAISSANCE EL TOTAL 2446 5 Seiten. American standard renaissance el total toilet installation instructions

Seite drucken

INSTRUCTIONS TO INSTALL TOILET SEAT

12a

Place seat on bowl. Be careful to

center hinge over holes in bowl.

12d

Use a screwdriver to tighten bolt.

NOTE: Pictures are representative and may not

exactly depict the flush valve.

LIFT ARM

FIRST

IMPORTANT: Always

clear sand and rust

from system.

• Make sure water supply

is off. Remove valve TOP

by lifting arm and rotating

top and arm 1/8 turn

counterclockwise, pressing

down slightly on cap.

GUARANTEE: This Fluidmaster product is guaranteed to be free from defective materials and

workmanship for a period of one year. Units returned to Fluidmaster will be replaced without charge.

Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster

shall not be responsible or liable for any damages caused by products used with Fluidmaster valves

that were not manufactured by Fluidmaster, Inc.

12b

Insert bolts in hinges.

12e

• While holding a

• Replace TOP by engaging

container over the

lugs and rotating 1/8 turn

uncapped VALVE to

clockwise. MAKE

prevent splashing, turn

CERTAIN TIP IS TURNED

water supply on and off

TO THE LOCKED

a few times. Leave

POSITION. VALVE MAY

water supply off.

NOT TURN ON IF TOP IS

NOT FULLY TURNED TO

THE LOCKED POSITION.

Close the hinge covers.

IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK

SLOWLY, repeat Step 13.

IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF

NON-USE, it is a signal you are wasting water because:

• The end of the refill tube is inserted into overflow pipe, below

water level in tank. Attach refill tube to overflow pipe using "S"

clip provided.

• The flush valve is leaking because it's worn, dirty or misaligned

with tank ball or flapper (replace with a new flapper).

IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL

OF TANK WATER IS SLOW after valve has been in use for

some time, Fluidmaster Model 242 Replacement Seal may be

needed.

Go to our website at www.fluidmaster.com for more

solutions to toilet problems.

For troubleshooting information please contact:

- 4 -

12c

Attach the nut from below.

12f

TOILET SEAT CARE AND CLEANING

When cleaning your toilet seat wash it

with mild, soapy water: rinse the seat

thoroughly with clear water: and dry

with a soft cloth.

Avoid detergents, disinfectants, or

cleaning products in aerosol cans.

NEVER use abrasive scouring powders

on your seat. Some bathroom

chemicals and cosmetics may damage

the seat's finish. After installation, check

the tightness of the bolts from time to

time to ensure a tight fit.

TROUBLESHOOTING

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675

(949) 728-2000 (800) 631-2011

www.fluidmaster.com

® Registered trademark of Fluidmaster, Inc.

7301186 -1 0 0 Re v. B