American Standard Retrospect Console Table 7812.295 Montage-/Installationsanleitung - Seite 3
Blättern Sie online oder laden Sie pdf Montage-/Installationsanleitung für Inneneinrichtung American Standard Retrospect Console Table 7812.295 herunter. American Standard Retrospect Console Table 7812.295 4 Seiten. Retrospect console table
Seite drucken
2
1) Move console table legs into approximate position near the
wall.
2) Place sink on console, aligning the rubber grommets on the
top of the front legs with the recesses in the underside of the
front of the sink.
3) Place a level on the shelf support and use the four
independently adjustable console feet to level the assembly
both side-to-side and front-to-back.
4) Place the level on the sink and use the two independently
adjustable trumpets on the tops of the rear legs to level the
sink.
5) Move the assembly into contact with the wall.
6) With a pencil, mark through the center of the two mounting
holes found on the back of the sink.
7) Move the assembly well clear of the wall.
8) Drill two pilot holes at the center marks using a 1/4" bit. Bore
in 1" deep.
9) Thread the two 5/16" headless hanger screws into the pilot
holes leaving 1-7/8" thread exposed in front of the wall.
3
Following manufacturer's instructions, install faucet and
drain assembly (not included) in sink. Be certain to apply
a bead of sealing putty on the underside of the drain to
ensure a watertight seal between the sink and the drain.
Remove excess putty immediately after tightening drain.
Move the assembly back toward the wall, guiding the
sink over the two headless hanger screws. Place
washers over studs and firmly hand-tighten nuts onto
each.
4
4
Connect the trap to drain assembly hand tight to check alignment. It may be
necessary to cut off part of the tailpiece (area "B") or part of the horizontal leg of the
trap (area "C").
Connect hot and cold supplies lines between the fitting valve and the supply shut-off
valves. Tighten trap joints for watertight assembly. Apply a bead of caulk around
the back edge of the sink where it contacts the wall. Insert the rectangular glass
shelf onto the shelf support.
Remove protective film from glass shelf.
Lavatory
- 3 -
Rear Leg
Adjustment
Bumper
Front Leg
Hanger Screw,
Grommet
Washer & Nut
of Console
Table
B
73 0 7 5 7 - 1 0 0 R EV. B
Feet are
adjustable
C