American Standard 2711L Installations- und Betriebshandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Badewannen American Standard 2711L herunter. American Standard 2711L 17 Seiten. Lifetime / evolution and renaissance whirlpools and bathtubs
Auch für American Standard 2711L: Installationshandbuch (15 seiten)
Seite drucken
- 1. Thank You
- 2. Table of Contents
- 3. Safety Instructions
- 4. General Information
- 5. Optional Components
- 6. Specifications
- 7. Roughing-In Reference
- 8. Roughing-In Reference
- 9. Framing and Support Instructions
- 10. Mounting Instructions
- 11. Electrical Connections
- 12. 6060L/V Corner EZ-Install Heater
- 13. Operation
- 14. Drain Connection and System Test
- 15. Care and Cleaning
- 16. Warranty
TYPICAL FLANGE MOUNTING DETAIL
SUGGESTED WHIRLPOOL / BATH
INSTALLATION METHOD
WOOD
STUD
STUDS
WATERPROOF DRYWALL
OR CEMENT BOARD
TILE
ROOFING NAIL
SEALANT
TUB
1 x 3 (25 x 76mm) WOOD
STRINGER FULL LENGTH
STEEL
STEEL
STUD
STUDS
WATERPROOF DRYWALL
OR CEMENT BOARD
TILE
SEALANT
TUB
SECURE THE BATH TO THE STUDS AS SHOWN
FOR WOOD OR STEEL STUD CONSTRUCTION.
UNDER DECK MOUNTING INSTRUCTIONS
Please note that care must be taken to protect the surface of the tub during all aspects of the installation.
Do not drill or cut the bath deck with the tub directly beneath it as damage to the tub may result.
1. Install the tub per the installation instructions provided with the unit.
2. Prepare the bath deck support structure per the local codes. Note - the bath deck must be self supporting.
3. Cut bath deck to your specifications.
4. Place the bath deck in position and trace the opening on the tub with a soft pencil. Do not drill or cut the bath
deck with the tub directly beneath it as damage to the tub may result.
5. Remove the bath deck and apply a generous bead of waterproof sealant on the outer edge of the traced line.
6. Replace the bath deck and secure it into place.
7. Apply additional sealant along the tub and bath deck interface as necessary to ensure a watertight seal.
8. Remove excess sealant per the manufacturer's instructions.
Finished bath deck surface material must be
self-supporting and secured per local codes
WASHER
4" (102mm)
DRYWALL
SCREW
1 x 3 (25 x 76mm) WOOD
STRINGER FULL LENGTH
Waterproof
Sealant
Bathtub
TYPICAL INSTALLATION -
19-1/2
(495mm)
TEMPLATE PROVIDED
UNLESS AN ACCESS OPENING OF AT LEAST
12" x 24" (305 x 610mm) IS PROVIDED,
WARRANTY SERVICE WILL NOT BE PERFORMED.
Tub support structure per installation
instructions provided with the tub
11
CORNER
WHIRLPOOL
ACCESS PANEL
* SEE CUTOUT
Bath deck support material
753737-100 Rev. E