American Standard Acrylux Builder 6030Y1.102 Series Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Badewannen American Standard Acrylux Builder 6030Y1.102 Series herunter. American Standard Acrylux Builder 6030Y1.102 Series 3 Seiten. American standard acrylux builder series bathtubs installation instructions

Seite drucken

INSTALLATION INSTRUCTIONS

STEP 1. PREPARING ALCOVE

• Strip to bare studs.

• Alcove studs should be constructed as shown above.

• Floor must be clean, smooth, and level (check with level). Sub

floor must be installed. Do not install tub on open floor joists.

• Cut hole in sub floor as shown on page 1 to accommodate drain.

STEP 2. INSTALLING TUB

• Trial fit tub in prepared alcove. With tub sitting flat on floor, check

with level on top of tub. Tub should be level from front-to-back

and side-to-side (Fig 1).

• A floor leveling compound (smooth mortar) or a similar

quick-setting compound specifically made for leveling floors may

be used to fully support and level base.

• After tub is leveled, if alcove is larger than tub, shim between tub

and studs to create a tight fit. Screw tub flange to studs (Fig. 2).

CLEANING

• Do not use any abrasive cleaners or metal scrapers.

• If drywall mud or plaster gets on your shower, it may be carefully removed with a wooden scraper made from

a piece of scrap wood.

• Adhesive may be removed with mineral spirits.

• Ideal cleaners are Soft Scrub Gel

WARNING:

Some cleaning products are not suitable for use. Read all labels carefully.

DO NOT USE if they say "not suitable for use with ABS, acrylic, or polystyrene.

or Comet Gel

- 2-

FIGURE 1. Check to assure tub is level.

FIGURE 2. If necessary, shim between tub and studs for

tight fit and screw to each stud.

75428 1 -1 0 0 Re v. A