American Standard Ropetwist Bathing Pool 2722.102 RHO Einbauanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Einbauanleitung für Badewannen American Standard Ropetwist Bathing Pool 2722.102 RHO herunter. American Standard Ropetwist Bathing Pool 2722.102 RHO 5 Seiten. Ropetwist bathing pool high gloss acrylic

Seite drucken

A.) THIS BATH MUST BE SUPPORTED ALONG IT'S ENTIRE BOTTOM. We recommend the use of mortar as bedding material (sand is not

recommended). Apply enough bedding to support the complete bottom of the bath. After the bedding has been poured, and before it sets,

position the bath within the recess until the rim is leveled against the leveling stringers (see "Typical Recess Installation") shown below. The rim

of the bath MUST NOT support weight. Allow the bedding material to completely harden before applying weight to the rim or bottom of the bath.

B.) Check level front to back and side to side, shim as necessary. To secure the tub to wood studs, use drywall screws with flatwashers or

roofing nails immediately above the flange of the bath. To secure the tub to steel studs, use 4" drywall screws and flatwashers.

C.) Any finish material such as tile or wallboard must be self-supporting if it contacts the deck of the bath.

Flooring will be butted against the bottom of the tub apron, also holding the tub in place.

TYPICAL RECESS INSTALLATION

60-3/16

(1529mm)

LE V E LIN G

S TR IN G ER S

TYPICAL FLANGE MOUNTING DETAIL

SUGGESTED BATH

INSTALLATION METHOD

WOOD

STUD

STUDS

WATERPROOF DRYWALL

OR CEMENT BOARD

TILE

ROOFING NAIL

SEALANT

TUB

1 x 3 (25 x 76mm) WOOD

STRINGER FULL LENGTH

STEEL

STUD

STUDS

WATERPROOF DRYWALL

OR CEMENT BOARD

TILE

SEALANT

TUB

STRINGER FULL LENGTH

SECURE THE BATH TO THE STUDS AS SHOWN

FOR WOOD OR STEEL STUD CONSTRUCTION.

34 Typ.

(864mm)

WASHER

4" (102mm)

DRYWALL

SCREW

1 x 3 (25 x 76mm) WOOD

754049-100 Rev. G