American Standard Virtuoso Whirlpool 7236.XXXW Einbauanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Einbauanleitung für Badewannen American Standard Virtuoso Whirlpool 7236.XXXW herunter. American Standard Virtuoso Whirlpool 7236.XXXW 4 Seiten. Whirlpool high gloss acrylic shown less all fittings
Seite drucken
INSTALLATION AND FRAMING INSTRUCTIONS
The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs
as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an
access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for
access to the drain components.
NOTE: The apron should not be used as the primary access opening.
1. Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary.
Mark the final position of the underside of the deck by tracing a line on to the studs (see Figure 1).
2. Remove the whirlpool and attach a 2 x 4 stringer to the studs, with the top of the stringer touching the traced line.
3. Install drain components to the whirlpool following the manufacturers instructions. Before replacing your whirlpool for final
installation, be certain that an opening has been provided in the sub-floor for the drain. See the roughing-in drawing for
suggested opening size and location dimensions.
4. Replace whirlpool and re-shim the integral support feet, shimming the entire length of the support feet. Secure the shims
using construction adhesive, silicone, mortar or equivalent materials. While not a necessity, the use of a foundation base
consisting of cement (e.g. Sakrete), mortar, or grout will help provide a solid and secure installation.
FIG. 1
19-1/4
(489mm)
TYPICAL RECESS INSTALLATION
19-1/4
(489mm)
72-1/8
(1832 mm)
TILE
TILE BEAD
STRIP
SEALANT
BATH
ADHESIVE
LEVELING
UNLESS AN ACCESS OPENING OF AT LEAST
STRINGER
12" X 24" (305 X 610MM) IS PROVIDED,
WARRANTY SERVICE WILL NOT BE PERFORMED.
750729-100 REV. H
L EV E L ING
S T R ING E RS
24
(610 mm)
NOTE: Tile bead kit not included and must be
TYPICAL PIER TYPE INSTALLATION
A S D E SI R ED
19-1/4
(489mm)
12
(305 mm)
MOUNTING SURFACE
WATERPROOF
SEALANT
SPIC AND SPAN ® IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE
(2)
TILE
WALLBOARD
SEALANT
TILE
BEAD
STRIP
ADHESIVE
LEVELING
STRINGER
purchased separately.
34-1/2
(876 mm)
CUTOUT
A S D ES IR E D
ACCESS PANEL
BATH
UNLESS AN ACCESS OPENING OF AT LEAST
12" X 24" (305 X 610MM) IS PROVIDED,
WARRANTY SERVICE WILL NOT BE PERFORMED.
BATH
70-1/2
(1791 mm)
CUTOUT
12
(305 mm)
24
(610 mm)