Da-Lite 29530 Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Projektionsfläche Da-Lite 29530 herunter. Da-Lite 29530 14 Seiten.

Installation (continued)

7. Mount the first lifting bracket (D) in the top section of the wall

opening behind the T-track (B). Measure 2⅛" from the back

(projector side) of the T-track (B) to the back edge of the

lifting bracket (D) and ½" from the edge of the opening to

position the bracket correctly. Use 1/4" x 1" lag screws to

attach the bracket (See Figure 4).

NOTE: Lifting brackets (D) must be parallel to T-track. When

installed in the correct orientation, the bottom lip of the lifting

bracket (D) will be the side closest to the T-track (B).

8. Repeat for the second lifting bracket (D) at the top section of

the screen in the opposite corner (See Figure 4).

Step 8

Step 9

Step 7

9. Position the third lifting bracket (D) 2⅛" from the back of the

T-track (B) in the center of the top section of the wall opening

and mount with 1/4"X 1" lag screws (See Figure 4).

NOTE: After completing this step, there should be three lifting

brackets (D) mounted into the top section of the wall opening

behind the T-track (B). Check that these brackets are secure.

They will be used to guide the screen surface into place and

support its weight until the T-track (B) and screen frame are

attached to each other.

WARNING: After completing this step, do not proceed

further in the instructions until the screen surface has

remained in a flat, unrolled state for at least 4 hours.

2⅛"

T-Track

Figure 4

Lifting Bracket

1/2"